Print Page | Close Window

dodge ram 1500 quad 2002 power locks issu

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=36998
Printed Date: June 17, 2025 at 4:22 PM


Topic: dodge ram 1500 quad 2002 power locks issu

Posted By: lowvoltagetech
Subject: dodge ram 1500 quad 2002 power locks issu
Date Posted: August 08, 2004 at 12:57 PM

hello,
i have installed a new alarm (clifford rs 2.5) with door unlock/lock and also disarm factory alarm.
i used the corect resistors stated on this site and now when the truck and alarm is off the door lock button only locks the doors
it does not unlock them. the alarm works fine. maybee i screwed something up

any suggestions?????????



-------------
lvt
lowvoltagetech.com



Replies:

Posted By: draasch
Date Posted: August 08, 2004 at 5:22 PM
it sounds like you dont have the right resistors in place.....i just helped someone with the same problem on a stratus....the info was wrong and he had to use a meter to measure the door lock wire to get the correct value...see if the following info helps...


Power Lock WHITE/ DARK GREEN 14 PIN CONNECTOR IN DRIVER #217
Power Unlock SINGLE WIRE SYSTEM KICK PANEL ***
*** WHITE/ DARK GRN Wire Must See Ground Through 820 Ohm Resistor For Lock And Ground Through 330 Ohm Resistor For Unlock.Alt: 220 Ohms. Confermed By More Than One Source The 220 Ohm Worked On Unlock. #217 See Single Wire Resistor Door Lock Circuit Diagram


OEM Alarm Arm LT GRN/ORANGE DRIVER KICK PANEL *
OEM Alarm Disarm SINGLE WIRE SYSTEM


*LT GRN/ORANGE-Arm/Disarm Must See A Ground Pulse thru a 1.5K Ohm Resistor To Arm/Lock and a Ground Thru A 550 Ohm Resistor To Disarm/Unlock Use Double Pulse Unlock.

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt





Print Page | Close Window