Print Page | Close Window

Alarm won’t shut off

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=37433
Printed Date: May 30, 2024 at 3:28 AM


Topic: Alarm won’t shut off

Posted By: Kobaltic
Subject: Alarm won’t shut off
Date Posted: August 15, 2004 at 3:12 PM

I got a used viper 350hv. I hooked it up and the alarm started blaring. I don't have the original remote to even try and shut it off. I can't program the new remote while the siren is active. I think  the alarm was going off when the battery got disconnected and the rapid resume logic is causing it to stay on. Is there a way to reset the rapid resume logic back to off? Could it be anything else? Any help would be great. Thanks.



Replies:

Posted By: draasch
Date Posted: August 15, 2004 at 4:15 PM
most alarms will go into trigger mode when you apply power to them.....i dont know what the steps are for DEI but, you should be able to use the valet button and override the system...

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt




Posted By: profuse007
Date Posted: August 15, 2004 at 4:45 PM
make sure yellow wire on primary harness is plug to a ignition. and power up all the necessary wire for the alarm and plug in the valet button. then w/ a key, turn to ign and press the valet button once and wait for 1-2 sec and the siren should cut off.

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).



Posted By: raydawg357
Date Posted: August 16, 2004 at 10:08 AM

Here is a copy of the install and owners manuals for that alarm:  https://www.directechs.com/guides/manuals/ig/viper/N426V_07-04.pdf

https://www.directechs.com/guides/manuals/og/viper/G426V_07-04.pdf



-------------
Do it right the first time



Posted By: Kobaltic
Date Posted: August 21, 2004 at 12:03 PM
Just wanted to say thanks. I got it working.


Print Page | Close Window