97 Cirrus alarm/remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=37757
Printed Date: May 10, 2025 at 5:25 PM

Topic: 97 Cirrus alarm/remote start

Posted By: Zeplin1073
Subject: 97 Cirrus alarm/remote start
Date Posted: August 19, 2004 at 4:34 PM

I put in a alarm with remote start but the only problem I have is when the car starts with the remote the interior light flash on for a brief second setting off the alarm. The car has a factory alarm which is being bypassed. Any clues to stop the lights from comming on?

Replies:

Posted By: mo12v
Date Posted: August 19, 2004 at 7:25 PM

Are you sure you have the right Dis-arm?

OEM Alarm Arm	L GREEN/ ORANGE (+)	BLACK CONNECTOR ON BACK *
OEM Alarm Disarm	L GREEN/ ORANGE (+)	OF FUSE/JUNCTION BLOCK

L GREEN/ ORANGE Single Wire Will Arm & Disarm. Must See 12 VDC (+) Thru A 873 Ohm Resistor To Arm And 12 VDC (+) Thru A 270 Ohm Resistor For Disarm.

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.

Posted By: Zeplin1073
Date Posted: August 22, 2004 at 10:56 PM

I didn't use the resistor since the tech guide I used didn't say anything about it. If the resistor is not used would that cause the interior light to come on for a brief second when it remote starts?

Print Page | Close Window