remove wire from harness

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=38039
Printed Date: July 18, 2025 at 3:16 PM

Topic: remove wire from harness

Posted By: kel789
Subject: remove wire from harness
Date Posted: August 24, 2004 at 6:50 PM

How do you folks remove extra wires that you don’t need from the harness?

Replies:

Posted By: heavilymedicate
Date Posted: August 24, 2004 at 6:54 PM

I dont. Zip -ie the ones i dont use out of the way and together, clip off the end of the small zip. Sometimes i do other things, depends on alot of things.

Posted By: profuse007
Date Posted: August 24, 2004 at 7:35 PM

-i see one installer did that and it was weird to see its missin cause when you go back to add something, the wire is gone. thats what happen to my buddy's viper 550esp.

-i just clip it down to a short length.

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: draasch
Date Posted: August 24, 2004 at 7:57 PM

you can always press the retainer down and remove them.....that way you can reuse them later on....but you wont have a ton of wires that are not being used.....

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: kel789
Date Posted: August 24, 2004 at 8:45 PM

good info. thanks.

Print Page | Close Window