I am needing a wire listing for a 2001 town and country remote start.
I need Ign 2 Acc. Tach and door locks and also wire colors for sliding passenger door and rear hatch release.
thank You
Make: Chrysler
Model: Town & Country (Van)
Year: 2001
Alarm
Constant 12 volts L BLUE (+) IGNITION SWITCH HARNESS *
Ignition 12 volts PINK/WHITE (+) IGNITION SWITCH HARNESS **
Starter YELLOW (+) IGNITION SWITCH HARNESS
Dome Light YELLOW/WHT (+) PIN 33 OF 34 PIN CONN. AT B.C.M.
Trunk Pin Switch VIOLET/ORANGE (-) PIN 29 OF 34 PIN CONN.AT THE B.C.M.
Parking Lamp WHT/BRN(RESISTOR SYS.) AT HEADLIGHT SWITCH (SEE TECH NOTES)
Power Lock VIOLET/D GREEN AT B.C.M.LOWER LEFT OF STEERING ***
Power Unlock SINGLE WIRE SYSTEM COLUMN IN PIN 21 WHT 34 PIN CONN.#217
* All Wires Are 20 Gage.L BLUE Fused At 10 Amps. For main Power Connection Connect To BROWN / RED Or WHITE/ RED Fused At 20 Amps At 6Pin Conn. At B.C.M. ** Ignition Wire Controls All Accessories. *** Chassis Ground Thru A 5.3k To Lock And Chassis Ground Thru A 2k Ohm Resistor To Unlock. ( Connector Is Third Up From Bottom Of BCM) #217- See Single Wire Resistor Door Lock Diagram
From Installer: Right Slider Open/Close Chassy Ground Thru 3900 Ohm Resistor On Glossy VIOLET / YELLOW at B.C.M Right Of Steering Column. Hood Ajar Switch - VIOLET/LIGHT BLUE (-) Pin 30 White 34 pin Conn. At B.C.M.
Remote Start
Tach Signal D BLUE/D GREEN PIN 11 GRAY/BLACK 40 WAY CONN.P.C.M.*
Ignition #2 #239
Ignition #3 **
Accessory
Neutral Safety WHITE/ LT GREEN PIN 9 OF 34 PIN CONNECTOR AT BCM
Brake Light WHITE/ TAN (+) AT SWITCH
Reverse Light WHITE/ LT GREEN (+) PIN 9 OF 34 PIN CONNECTOR AT BCM
Rear Window Defrost
* Power Control Module Located Left Front Corner Of Engine Compartment. Ignition Input To Keyless:PINK/WHITE ** VIOLET/BROWN and VIOLET/ORANGE Must See 180 OHM Resistor Between Them During Start Due To Multiplexing. #239 - See Immobilizer Bypass Diagram.
This Vehicle Has A Resistered Park Light System.The WHITE/ BROWN Wire Must Be Cut And A relay And Resistor Must Be Used. Pin 85 To Ground Pin 86 To The WHITE Wire Of The Alarm.Pin 87A Switch Side Of WHITE/ BROWN Wire,Pin 30 BCM Side Of WHITE/ BROWN Wire. Pin 87 To One Side Of A 5.8k Ohm Resistor,The Other Side Of The Resistor To Ground. There Is A WHT/DK.BRN In The Rear Harness (Driver Kick) That Is A Pos 12v To The Tag Lights. (From Installer) From Installer: Door Lock/Unlock Wire Located On The Third Connector Up From The Bottom.
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
thanks bro.
cant find muliplexing diagram #239 can any one remember how to do it
Omega #239
Only if you have GRAY Ignition Key..........
Cheap way...............Wire wrap around key thru Relay
Better way...................Extra Coded Ignition Key in Immobilizer Box
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
no grey key it is built in to the ign. switch need a relay with a res. cant remember how to do it
https://www.wiringinstructions.com/239.htm
i would just buy a by-pass if you need one.....dont take the easy way out.....
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt