Print Page | Close Window

keyless entry programing

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=38077
Printed Date: May 23, 2024 at 6:18 AM


Topic: keyless entry programing

Posted By: cacheli1266
Subject: keyless entry programing
Date Posted: August 25, 2004 at 11:25 AM

how do i program a keyless entry remote for a lincoln navigator 98...

thanks




Replies:

Posted By: mo12v
Date Posted: August 25, 2004 at 6:33 PM
1998 (Windstar/Escort/Tracer/Navigator): Cycle the ignition from OFF to RUN/ACC eight (8) times within 10 seconds, ending in RUN/ACC, or cycle the ignition from OFF to START four (4) times within 10 seconds, ending in RUN. The power door locks should cycle LOCK to UNLOCK to confirm entrance into Program Mode.

2. Press any button on a remote entry transmitter. The power door locks should cycle LOCK then UNLOCK to acknowledge transmitter code.

3. Repeat Step 2 for any additional remote entry transmitters that need to be programmed to the vehicle.

4. Turn the ignition switch to OFF to exit Program Mode. To confirm Program Mode has been exited, the power door locks will cycle LOCK then UNLOCK one last time.



-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.



Posted By: mo12v
Date Posted: August 25, 2004 at 6:34 PM
That is if you are programming the correct FACTORY Remote

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.


Print Page | Close Window