2000 Olds Alero

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=3810
Printed Date: May 10, 2025 at 6:48 AM

Topic: 2000 Olds Alero

Posted By: alero
Subject: 2000 Olds Alero
Date Posted: September 19, 2002 at 9:21 PM

I have installed Bulldog keyless entry on my Alero, using the wiring information from the Bulldog site. I can't locate the park light circuit on the BCM. the diagram says brown + on the grey 16 pin connector. There is only one brown wire on that connector and it shows nothing other than constant ground, no pulse or voltage when the doors lock. Any ideas or just go for the park light wiring off the switch?

Thanks

Replies:

Posted By: Velocity Motors
Date Posted: September 20, 2002 at 5:30 AM

Try looking over in the passenger kick panel as well for the BROWN wire

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: kickyride
Date Posted: September 20, 2002 at 11:01 AM

The brown wire is at the head light switch in '99-00 aleros and is behind the radio on '01-02 cars. Hope this helps.

Mike

-------------
Mike
Sales/Tech Support - KICKYRIDEoCOM mobile electronics
MECP 1st class-Security Specialist

Posted By: alero
Date Posted: September 20, 2002 at 5:03 PM

Thanks for the help, but this car has the built in lock delay. Waits about 5-7 seconds from last door close, then locks the door and flashes the parking lights twice. This has to be coming from the BCM, so why would I need to go right to the light switch??

Alero

Posted By: alero
Date Posted: September 21, 2002 at 9:24 AM

Continued message 3

Probed every wire on the BCM and no luck, finally took kickyride's advice and just used the headlight switch wireing, much easier and works fine.

Thanks for the help

Print Page | Close Window