Print Page | Close Window

magicar fai-300 alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=38229
Printed Date: July 19, 2025 at 9:05 PM


Topic: magicar fai-300 alarm

Posted By: bkelley
Subject: magicar fai-300 alarm
Date Posted: August 28, 2004 at 11:27 AM

I am installing a car alarm in my truck. I have shaved door handels so Im hooking one door up to the unlock button and the other door to the trunk release button. When I went to hook the first door up I was not getting a strong enough volts out of the wire to open the door. So I put a relay on it and it works fine. So I did the same thing for the sencond door but its like the trunk release wire is not strong enough to even activate the relay. I did put a tst light on the wire and it does light up very little. I have swap relays to make sure they work and they do. So how can I make the volts strong enought to activate the relay?

It is a magicar fai-300 alarm.

One more question is there a way I can make the alarm unlock one door when I hit the button once and the other door when I hit it the button more?

The alarm has a built in central door lock module if this matters.




Replies:

Posted By: bkelley
Date Posted: August 29, 2004 at 7:38 PM

thanks for any kind of help




Posted By: BNLUIS
Date Posted: August 29, 2004 at 8:16 PM
usally when u use an aux output uneed to hold the button for a few seconds to access the channel

-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.


Print Page | Close Window