dei55p bypass module
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=38631
Printed Date: July 26, 2025 at 2:07 AM
Topic: dei55p bypass module
Posted By: bobafett/7
Subject: dei55p bypass module
Date Posted: September 05, 2004 at 12:43 PM
trying to wire this to a 97 probe but I dont understand what they mean in the wiring list for pin 5&7 they are listed as immobilizer data tap and immobilizer sync tap and on the car side they are for tap immobilizer pins 3/4 are these the wires for the transponder if so then what are pins 8/9 for as they are listed as ign. car side & ign. key side
-------------
bobafett/7
Replies:
Posted By: Velocity Motors
Date Posted: September 05, 2004 at 12:54 PM
The 97 Ford Probe doesn't have PATS. You should be able to direct connect a remote starter to the car without having to use the 555P.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: bobafett/7
Date Posted: September 05, 2004 at 1:13 PM
no my one has the same system as the mazda with the little red plug on the key an a plastic housing on the lock cylinder with 2 green wires
-------------
bobafett/7
Posted By: Velocity Motors
Date Posted: September 05, 2004 at 5:57 PM
Have you tried installing the system without the DEI unit to see if it starts for you ? I still don't think the system you have is PATS. The Mazda MX-6 did not have the immobilizer system in it either.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: Teken
Date Posted: September 05, 2004 at 6:31 PM
As it was stated before, the Ford Probe does not have PATS, if there is something there now, it is after market, not OEM.
Regards
EVIL Teken . . .
Posted By: bobafett/7
Date Posted: September 06, 2004 at 5:37 AM
no it won,t go unless there is a key next to the ignition barrel the 97 probe in the uk had the transponder fitted after all the problems they had with the bosch immobiliser I just don,t understand what they mean by immobiliser data & sync tap
-------------
bobafett/7
Posted By: Velocity Motors
Date Posted: September 06, 2004 at 2:05 PM
Just use a universal key required bypass module instead then. Will do the same except you loose a key.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: bobafett/7
Date Posted: September 06, 2004 at 4:06 PM
looks like I,ll need to as Ican,t figure out what these wires are for the instructions are very vague thanks for the advice anyway guys much appreciated
-------------
bobafett/7
|