790vx shock sensor
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=38635
Printed Date: July 23, 2025 at 8:51 AM
Topic: 790vx shock sensor
Posted By: crazy_russian
Subject: 790vx shock sensor
Date Posted: September 05, 2004 at 2:29 PM
hi,
I'm trying to install a viper 790vx into my honda civic and was wondering if some one can tell me what the green wire on the shock sensor harness is for since it doesn't connect into the shock sensor? it shows as mutlitiplex input zone 4 in the instal manual.
Thanks
Replies:
Posted By: draasch
Date Posted: September 05, 2004 at 5:25 PM
i believe it is for pre-warn.....for a dual stage sensor.... ------------- Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Posted By: crazy_russian
Date Posted: September 05, 2004 at 11:34 PM
hi,
thanks I got the alarm installed (for the most part any ways) I still have to hook up the remote start and power door locks, but all the doors,trunk and hood sensors all work. (just ran out of daylight) now I just need to figure out how to increase the sensitivity of the shock sensor, I was hoping I would be able to do it through the remote or valet switch, but I didn't notice anything about adjusting the sensors in the manual, does any one know how I would go about doing this?
the sensor is mounted directly to the frame using double sided tape. one other thing that I'm not sure about is the led it works fine and flashes normal when armed,but when the system is disarmed it flashes twice about every 2.5 seconds would this be some kind of diognostic?
Thanks,
B
|