2005 Chrysler 300, remote start/airbag light

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=39183
Printed Date: May 06, 2024 at 7:13 AM

Topic: 2005 Chrysler 300, remote start/airbag light

Posted By: Big Dog
Subject: 2005 Chrysler 300, remote start/airbag light
Date Posted: September 15, 2004 at 11:36 AM

Has anybody had AIBAG light come on after doing r-start and WireMagic's method of doing 2nd ign and crank?

Replies:

Posted By: larkster
Date Posted: September 15, 2004 at 12:30 PM

only done one. the ignition circuit is the same as the caravan. second starter wire PURPLE / brown negative with 180ohm resistor. not sure what wiremagic says but i dont remember there being a second ignition wire.

Posted By: jcap
Date Posted: September 15, 2004 at 11:59 PM

if you hooked up the wiring bypass as per wire magic method . the cruise control will not wokring also.

-------------
jcap

Posted By: another-kelly
Date Posted: September 16, 2004 at 12:16 AM

here's DEI's:

12volts	lt. blue/red (15A)	+	ignition harness
Starter	pink/dk. green	+	ignition harness
Second Starter	PURPLE / brown	-	ignition harness
Ignition	pink/white	+	ignition harness
Second Ignition
Third Ignition
Accessory	PURPLE / brown	-	ignition harness

CHRYSLER, 300, 2005, Second Starter

The second starter wire is negative trigger thru an 180 ohm resistor. MUST use a relay. Refer to DirectFax document 1083 for wiring information.

https://www.directechs.com/techtips/pdfs/resources/security/directed_techtips/1083.pdf

Posted By: larkster
Date Posted: September 16, 2004 at 8:14 PM

did one today again...cut PURPLE / brown wire measured it. this wire does keysense 8.4k starter 180ohm and accessory 620ohm. i hooked up the second starter and the acc and everything works fine. no airbag light on and test drove cruise works fine...however i did have the check engine light come on...anybody else

Posted By: extreme1
Date Posted: September 16, 2004 at 11:40 PM

I use a DEI 456L resistance learning module for 2nd ign/start.

-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta