99 Jeep Viper 791
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=39744
Printed Date: May 16, 2024 at 5:53 PM
Topic: 99 Jeep Viper 791
Posted By: Autosexual
Subject: 99 Jeep Viper 791
Date Posted: September 25, 2004 at 9:05 PM
I am installing the Viper 791 alarm with the DEI 55C bypass module in a 99 Jeep Grand Cherokee, but I am not sure which wire the blue wire from the 555C to connects to with the 791. The directions say to connect it to the (-) through activation output of the remote start system, but which wire is that?
Replies:
Posted By: hagmanti
Date Posted: September 25, 2004 at 10:29 PM
The blue wire on the remote start primary harness.
Me
Posted By: gus1
Date Posted: October 02, 2004 at 3:35 PM
On the XRCS (relay satellite thing) there is a 4 wire plug next to the ribbon satellite harness. This 4 wire plug has a blue, pink, purple, and orange wire in it. The blue wire is the -status/ground when running output that you will need to connect to the blue wire on your 555C.
Gus
-------------
Wherever I go, that is where I end up......
Posted By: Autosexual
Date Posted: October 03, 2004 at 6:59 PM
I am trying to find the neutral safety wire in a 99 Jeep Grand Cherokee limited, can someone direct me to it? For a bonus question, I am putting in a Viper 791 and I am using the DEI interface for the door locks but when I lock the doors I am getting the horn as well as the chirp letting me know that the alarm has been activated. Does anyone know how to eliminate the horn or tell me what I might of done wrong?
Posted By: mo12v
Date Posted: October 03, 2004 at 7:21 PM
I have: BROWN / Yellow ( - )at Switch onTransmission or PCM (located on passenger rear of engine compartment) ------------- MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
Posted By: jmr964
Date Posted: October 03, 2004 at 8:33 PM
Regarding the horn honk go to the overhead console and go through the menu options and turn the horn off. I have a JGC that doesn't have the factory alarm so I don't know if this will be the same or not but it lets you select if you want the horn to honk when locking and unlocking the doors with the factory keyless entry. Give that a try and let me know. Jason
Posted By: Autosexual
Date Posted: October 21, 2004 at 9:57 PM
That was a verry simple solution for the horn honk thanks. As for the neutral saftey wire I am still coming up with nothing. I do not find a BROWN / yellow at the switch. What else do you have that might get me there.
Posted By: Autosexual
Date Posted: October 21, 2004 at 9:59 PM
Thanks that did the trick.
Posted By: isus
Date Posted: October 21, 2004 at 10:09 PM
Just ground the wire. That will solve the issue.
|