Compustar alarm sys.

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=39792
Printed Date: June 09, 2024 at 3:46 AM

Topic: Compustar alarm sys.

Posted By: thousandandone
Subject: Compustar alarm sys.
Date Posted: September 26, 2004 at 6:43 PM

Hi,

My Compustar CM3000 install to 91 Legend

Pin #1: ORANGE- This is the Rearm wire. It provides you with a (-) pulse when armed, after remote start and then again one second after remote start shuts down.

Pin#2: ORGANGE/WHITE- This is the Disarm wire. It provides you with a (-) pulse when disarmed and before remote start.

My question is: What do they mean?. Where do I connect this two wires to

Thank You

-------------
Autostar

Replies:

Posted By: Teken
Date Posted: September 26, 2004 at 7:01 PM

These wires turn on-off any factory alarm system, prior and after a RS.

Regards

EVIL Teken . . .

Posted By: snguyen
Date Posted: September 26, 2004 at 8:52 PM

FACTORY ARM

GREEN/ YELLOW

at anti-theft module**

**THE keyless entry module and the anti-theft module are both mounted on the right side of the steering column.

FACTORY DISARM

GREEN/ red

at anti-theft module**

** The keyless entry module and the anti-theft module are both mounted on the right side of the steering column.

Print Page | Close Window