Print Page | Close Window

Window modules

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=39824
Printed Date: June 17, 2025 at 6:52 PM


Topic: Window modules

Posted By: jaurora
Subject: Window modules
Date Posted: September 27, 2004 at 6:18 AM

I am new at this window module thing. I have installed a prestge APS-996a into my girlfriends car without any problems. I have a DEI 530T window module to install. Now the 530T is self explainitory on the wiring connections and wiring it is not the problem. My problem is I cant seem to find the wires that I need. Everyone tells me at the switch in the door but this seems to be impossible. There is one harness with about 6 wires that connects to a black plastic switch box (LOCKS AND WINDOWS) and not to switches. The car is a 2Dr Stratus R/T 2002. Not to many people have been able to help me with this car. The model is a R/T not a sadan or coupe. If someone can please help me out with te proper wires for the windows and their locations this will be extremly helpfull. Thanks to all the people of 12 Volt.com.



-------------
MECP certified (If it really means anything)
Jeremy



Replies:

Posted By: mo12v
Date Posted: September 27, 2004 at 1:10 PM
Can U give the colors at your door swich?

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.




Posted By: jaurora
Date Posted: September 27, 2004 at 2:27 PM
I would have to rip off the door skin again. I know that someone gave me a tech sheet on this car and only ~3 wires were correct throughout the whole wiring detail. I know that there is 2 small ~26AWG wires and ~4 18 AWG wires. When all the wires were measured they all read open no matter what window you operate up or down. as the same for the power locks.

-------------
MECP certified (If it really means anything)
Jeremy




Posted By: mo12v
Date Posted: September 27, 2004 at 2:54 PM

Window Up

Dr\ LT BLU Pas\ BRN/WHT DrRear\ BLU/WHT
PasRear\ GRY/BLK *

Window DownDr/ WHITE Pas/ VIO/WHT DrRear/ RED / BLK
PasRear/ GRN/WHT
SEE NOTES
Ign Key Warn
Trunk ReleaseBLACK/ WHITE (+)BCM CONN #4 Pin #1 **
OEM HornBLACK/ RED (-)STEERING COLUMN HARNESS
HeadlightsVIOLET/WHITE (+)AT HEADLIGHT SWITCH
OEM Alarm ArmLT GREEN/ ORANGE (+)BCM CONN #4 PIN #4 BCM AT DRIVER
OEM Alarm DisarmSINGLE WIRE SYSTEMFUSE/RELAY BOX ***

* Main Switch For Driver Window Wires, Driver Kick For All Other Windows
Reversal Rest At Ground Type Window Circuit
** From Install BLACK/ WHITE (-)  At Switch. *** ARM-Needs To See +12v Thru 1.8 K Ohm Resistor, DISARM- Needs To See +12v Thru 750 Ohm Resistor       Reversal Rest At Ground Type Trunk Pop Circuit 



-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.





Print Page | Close Window