door trigger input

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=39849
Printed Date: June 19, 2025 at 8:30 PM

Topic: door trigger input

Posted By: W211_RYDA
Subject: door trigger input
Date Posted: September 27, 2004 at 2:48 PM

I was trying to install a Clifford Matrix RSX 1.5 yesterday and noticed that it doesn't have any wire for the door trigger input. Doesn't this feature come standard on all alarms? Is there any way I could wire in a door trigger input for this alarm? If not, I guess I'll have to sell this alarm and get a new alarm.

Replies:

Posted By: Teken
Date Posted: September 27, 2004 at 3:56 PM

The RSX 1.5 is not an alarm system, it is a RS unit. If you wish to have the doors kill the vehicle upon entry. Then simply diode isolate the door trigger and tie into the hood input, or similar input. H3/2 gray (-) wire

Regards

Posted By: W211_RYDA
Date Posted: September 27, 2004 at 8:59 PM

Thanks for clarifying this for me Teken. Just bought an Avistart 6001 from my friend and I'll be selling the Matrix. The Avistart has all the features I need. This is one expensive lesson. posted_image

Posted By: Teken
Date Posted: September 27, 2004 at 9:22 PM

Well, look at this way. It all turned out for the best, and you will have what you really needed.

REMEMBER: It's never a problem, if money can fix it. If money cannot fix the problem, then indeed it is a problem.

Regards

EVIL Teken . . .

Posted By: snguyen
Date Posted: September 28, 2004 at 11:22 AM

Well put Teken!

Print Page | Close Window