I am still working on installing the Crime Guard 745i2 in my daughters 95 Mustang Convertible.
I am now starting on the door locks, power window modules are next (hint hint).
We bought the car a couple months ago, and only got a set of keys from the previuos owner, so I don't know if it had factory keyless entry. I know that I am suppose to find the pink / yellow and the pink / green wires in the drivers kick panel. But there is ALOT of wires there.
Can someone please help me find these? Are they high or low? In which bundle? On a colored plug? And how can I determine if the car has or had keyless entry, so I know how to wire the alarm?
While I'm at it, anyone want to tackle on telling me how to hook up the DEI 530T? What wires and where are they? I have two, one for four windows up and the other for down.
U could go to door frame boot and hook up wire there. The wires U want will show 12 volts+ when activating door switch
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
The door frame boot comes into the kick panel area very high. It will be difficult to pull a wire(s) into there, but not impossible.
I was hoping that someone could tell me where the wires are in the mass amount located in the kick panel.
Also, any thoughts on the wires for the windows? I am going to install roll up and roll down modules.
Thanks again, tas
U will probably have to go into door panel for windows & door locks Unless U can get the harness that runs thru door pillar to pull down, which is pretty hard. I usually run my wires thru boot into door and hook up in the door
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.