clifford eagle 2
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=40276
Printed Date: May 08, 2025 at 2:56 PM
Topic: clifford eagle 2
Posted By: webstar
Subject: clifford eagle 2
Date Posted: October 04, 2004 at 3:01 PM
HI out there can anybody help with install guides for a clifford eagle 2 i am pulling my hair out with the dual imob/starter/ignition kill does it need to be grounded ? i have connected most wires but think the dual kill needs to be fitted for it all to work correctly. also 2 black with red stripe wires have diodes on then what is this for ? clifford dealer just says buy a new alarm . many thanx in advance.
Replies:
Posted By: Teken
Date Posted: October 04, 2004 at 9:28 PM
What is the North American name for this unit??
Regards
EVIL Teken . . .
Posted By: webstar
Date Posted: October 06, 2004 at 5:20 PM
Hi Tek Ill try find out. ------------- webs
Posted By: webstar
Date Posted: October 06, 2004 at 6:21 PM
Hi Again
I think it could be falcon 2 or intellivoice IQ hope these are the ones.
-------------
webs
Posted By: Teken
Date Posted: October 06, 2004 at 8:20 PM
https://www.directechs.com/guides/manuals/ig/clifford/intellivoice4_install.pdf
This is the the Intellivoice IQ 4 installation manual.
Regards
EVIL Teken . . .
Posted By: webstar
Date Posted: October 06, 2004 at 8:41 PM
Hi Nice one its a start and will help thanks ------------- webs
Posted By: Teken
Date Posted: October 06, 2004 at 9:00 PM
If you are looking for the alarm system. Please locate the North American name for me, and I will try to locate it for you.
Regards
EVIL Teken . . .
Posted By: webstar
Date Posted: October 07, 2004 at 10:16 PM
Hi It could be the cyber 3 or bullet 2. Thanks ------------- webs
Posted By: Teken
Date Posted: October 08, 2004 at 8:34 AM
Posted By: Teken
Date Posted: October 08, 2004 at 8:35 AM
Posted By: Teken
Date Posted: October 08, 2004 at 8:40 AM
https://www.directechs.com/guides/manuals/ig/clifford/bullet4_install.pdf
This is for the Bullet 4. Perhaps looking at the 3 wiring diagrams will help you resolve your questions.
Regards
EVIL Teken . . .
Posted By: webstar
Date Posted: October 08, 2004 at 9:20 PM
Wow you are a star. Im sure this will help loads wire colors are almost identical and sensors . let ya know how i get on cheers webs
Posted By: Teken
Date Posted: October 08, 2004 at 9:51 PM
Best of luck. Just take your time in doing so.
Regards
EVIL Teken . . .
Posted By: webstar
Date Posted: October 10, 2004 at 4:08 PM
Diagrams and other info were spot-on alarm and sense and tell module working as it should.
Smart windows is getting there slowly .
Not sure if the windows need programing because i was in valet mode when installing and it shuts windows but leaves an inch vent when arming the alarm in valet mode but when out of valet they dont close or move at all.
thanks again Tek my car is safe from tea leaves again.
-------------
webs
Posted By: Teken
Date Posted: October 10, 2004 at 4:42 PM
Which iteration of Window are you using? Perhaps I can read over the installation manual and shed some light on the matter.
Regards
EVIL Teken . . .
Posted By: webstar
Date Posted: October 10, 2004 at 6:31 PM
Smart windows 2 is what im using
the guide on how to install window closure modules you posted in my othe thread helped loads and i think i got most of it correct because the windows still operate o.k
only thing thats changed is passenger side now works as one touch operation same as driver side .
drivers side window needs 2 taps of the window switch instead of orginal one touch but still fully closes.
you can here the relays in the smart windows module clicking away .
-------------
webs
Posted By: sharkey
Date Posted: October 30, 2004 at 4:40 PM
i know im bringing this topic up from the dead, but since we are on the topic of wiring diagrams, does anyone have one for the clifford cyber 5???
|