clifford smart windows 2

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=40494
Printed Date: May 14, 2025 at 1:46 AM

Topic: clifford smart windows 2

Posted By: webstar
Subject: clifford smart windows 2
Date Posted: October 07, 2004 at 10:34 PM

First to say i am very new to this but trying.

when fitting smart windows 2 the diagram states to look for 12v on the window switch when pressing up or down then cut this wire and attach orange wire to motor side and blue to switch side and vice versa passenger switch.

but when i test for 12v on the switch its there already and goes to 0 volts when the switch is pessed.

i know im a bit slow but this is confussing.

Any help

-------------
webs

Replies:

Posted By: Teken
Date Posted: October 08, 2004 at 3:37 PM

It would be most helpful to know the vehicle make, model, year, which this device is being installed into.

Regards

EVIL Teken . . .

Posted By: webstar
Date Posted: October 08, 2004 at 9:16 PM

Hi Teken

The vehicle is a 1996 Fiat coupe turbo 16valve 2.0 and its driving me nuts.

But thanks for all your help so far.

webs

Posted By: Teken
Date Posted: October 08, 2004 at 9:58 PM

DIRECTWIRE™ WIRING INFORMATION - FIAT / COUPE (UK) / 1994 / Remote Start

12volts
Starter
Second Starter
Ignition ORANGE / white      ignition harness
Second Ignition
Third Ignition
Accessory
Second Accessory
Keysense
Power Lock lt blue    -   entry point from door to veh
Power Unlock white    -   entry point from door to veh
Lock Motor
Unlock Motor
Parking Lights+ blue & blu/blk     rear of the fusebox
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger BLACK/ violet    -   rear of fusebox, conn G or E
Dome Supervision
Trunk/Hatch Pin BLACK/ violet      at the bootlight
Hood Pin
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer
Wait to start
Brake Wire
Parking Brake
Horn Trigger
Memory Seat 1
Memory Seat 2
Memory Seat 3
Immobilizer Bypass Module: Not Available


This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.

The wiring is for a 1994 Fiat Coupe, perhaps this will give you some reference.

Regards

EVIL Teken . . .

Posted By: Teken
Date Posted: October 08, 2004 at 10:03 PM

This link will summerize for you the back ground and theory as to how to interface the window module.

Please take a few moments to review the material, and hopefully this will answer your Q's.

Regards

EVIL Teken . . .

https://www.directechs.com/techtips/pdfs/resources/security/directed_techtips/1042.pdf

Posted By: webstar
Date Posted: October 08, 2004 at 11:32 PM

Many thanks Teken

This lot is spot on .

Many, Many thanks

-------------
webs