gmdl-bp?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=40600
Printed Date: May 16, 2024 at 3:10 AM
Topic: gmdl-bp?
Posted By: sahall32
Subject: gmdl-bp?
Date Posted: October 09, 2004 at 9:56 PM
I'm installing a alarm/remote start combo and have the gmdl-bp to interface the data bus. I have one question about the connections on the gmdl-bp. On the pink wire it states * dome light input from vehicle* would that be the dome light wire from the alarm/rs unit or from the actual vehicle? thanks, Steve
Replies:
Posted By: Dauber
Date Posted: October 09, 2004 at 10:21 PM
Sahall32 I have done a few of these units and what that means is that you have to find a domelight source from the vehicle to go to this pink wire, then it will give you door triggers on the output of the GMDL-BP. It works pretty good, kinda like the old GMDAA's if you have ever used one. But let me know what kind of vehicle, maybe I can tell you the domelight wire. Hopefully this helps you.
-------------
Kyle@Audio Obsession Sound
Posted By: sahall32
Date Posted: October 09, 2004 at 10:30 PM
that was kinda stupid huh?? 2004 trailblazer
Posted By: Dauber
Date Posted: October 11, 2004 at 1:44 AM
That one I don't know but hopefully you found it by now! But its never a stupid question to ask, especially if your unsure, better safe than sorry, especially on a vehicle like that!
-------------
Kyle@Audio Obsession Sound
Posted By: Teken
Date Posted: October 11, 2004 at 2:39 AM
DIRECTWIRE™ WIRING INFORMATION - CHEVROLET / TRAILBLAZER / 2004 / Remote Start
12volts red (40A), RED / white (40A) + ignition harness
Starter yellow + ignition harness
Second Starter N/A
Ignition pink + ignition harness
Second Ignition white + ignition harness
Third Ignition N/A
Accessory orange + ignition harness
Second Accessory brown + ignition harness
Keysense lt. green - ign harn or BCM, tan plug, pin E3
Notes: The BCM is attached to the fuse box under the left rear seat.
Power Lock use Directed module 455G
Notes: If Directed module 455G is not available, refer to DirectFax document 1053.
Power Unlock see power lock
Lock Motor gray 5wi driver door module in door
Unlock Motor tan 5wi driver door module in door
Parking Lights+ brown + fuse box under left rear seat
Parking Lights- gray/black - switch or BCM, tan plug, pin E5
Notes: The BCM is attached to the fuse box under the left rear seat.
Hazards white - steering column
Turn Signal(L) dk. green + steering column
Turn Signal(R) lt. green + steering column
Reverse Light lt. green + fuse box under left rear seat
Door Trigger gray/black + fuse box under left rear seat
Notes: To avoid dome light delay, use the separate door trigger wires. The LF door is gray/black (-) at the driver door module in the door. The RF door is BLACK/ white (-) at the passenger door module in the door. The LR door is lt. blue/black (-), and the RR door is lt. GREEN/ black (-). The rear door trigger wires are at the fuse box under the left rear seat. Use all four wires and diode isolate each.
Dome Supervision comes on with disarm
Trunk/Hatch Pin common with door trigger wire
Notes: To avoid dome light delay, use the separate trigger wires at the liftgate module in the liftgate. The liftgate is pink/black (-), and the glass hatch is purple (-). Use both wires and diode isolate each.
Hood Pin pink/black (export only) - switch or BCM, tan plug, pin E6
Notes: The BCM is attached to the fuse box under the left rear seat.
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm arms with 455G
Factory Alarm Disarm disarms with 455G
Disarm No Unlock lt. green (if no 455G) - driver door module in door
Tachometer white ac PCM
Notes: 4.2L: The PCM is attached to the driver side of the engine. Tach is in the blue plug, pin 49.
5.3L: The PCM is near the lower front driver side of the engine. Tach is in the green plug, pin 10.
Wait to start N/A
Brake Wire white + brake pedal switch
Parking Brake lt. blue - switch or BCM, blk plug, pin A4
Notes: The BCM is attached to the fuse box under the left rear seat.
Horn Trigger BLACK / YELLOW to black - column or BCM, tan plug, pin E12
Notes: The BCM is attached to the fuse box under the left rear seat.
Memory Seat 1 white + driver door module in door
Memory Seat 2 purple + driver door module in door
Memory Seat 3 N/A +
Immobilizer Bypass Module: Required: Yes Type: Passlock 2 Part #: 555L or 555T
Notes: The Passlock 2 wire colors are yellow, ORANGE / black (to black), and RED / white (not used).
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Posted By: sahall32
Date Posted: October 14, 2004 at 2:26 PM
I appreciate all the help so far. I do have a gmdaa module on hand will that work ok with that vehicle? Steve
Posted By: Dauber
Date Posted: October 14, 2004 at 11:51 PM
Just a question but on the GMDAA does it say it will do a trailblazer, I'm pretty sure that it will do it, but one question, or I should say make sure that is a version 2.7 or up, or a 2.4, otherwise you might wind up into some difficulties. Otherwise using the GMDAA is like pie. You'll see what I mean once you install it. Let me know how it goes.
-------------
Kyle@Audio Obsession Sound
Posted By: sahall32
Date Posted: October 15, 2004 at 12:37 PM
It syas it will fit the 04 trailblazer and the gmdaa is version 2.8. Should that work ok without any problems.
Posted By: sparkie
Date Posted: October 15, 2004 at 4:34 PM
Yes it will. The GMDL-BP isn't recommended on the Trailblazers and Envoys. The manufacturers are having problems on these vehicles with that module. They say they are coming out with a revised version shortly. The only problem you may have is if you have a 8 cylinder motor. I had a few people tell me the GMDAA doesn't like those motors.
-------------
sparky
Posted By: Dauber
Date Posted: October 16, 2004 at 10:16 AM
That should work perfect.
-------------
Kyle@Audio Obsession Sound
Posted By: sahall32
Date Posted: October 16, 2004 at 12:30 PM
it works great I guess i missed the door trigger wire alarm not activating when door is open but should be a simple fix though, thanks for all the help Steve
|