i am seriously considering purchasing an ungo sr5000, but i am wondering about the wiring for the locks. My '87 porsche 944 has manual locks, and i am wondering what kind of relay wiring i should use for this alarm. I am 16 and i am most definitely competent enough to install it, but the alarm has 2 wires that switch outputs from - to + depending on if it is locking or unlocking (i. e. lock a="+"b="-", unlock a="-" b="+")
is this a situation where i use a 3 wire relay setup? i know that i need to use relays, because the installation manual for the alarm says that and little else install. manual (go to page 18) also, which actuators should i get? which relays are needed? thanks.
Depending on the Door Lock kit that U buy, your Alarm will be able to trigger a Central Door Lock Kit that has a Relay for them or if U buy independent door lock motors, U will have to wire Relays and hook up your Alarm wires to them.
Get the complete kit together
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
Okay your gonna need two door lock actuators hook those two motor to the stick that does the locking n unlocking .you need to run those two wires in from each door to the alarm . the concept for the motor is real simple + on one end and - on the other makes it move in one direction reverse the polarity n it move the other way. so your gonna need two relays basically any automotive relay will do i perfer bosch . hook fused 12v constant to 86 and 87 both relays , and 87a both relays goes to ground , and hook the blue to the 85 on one relay and the other relay 85 get the green. now u got two wires coming from each door make sure u know which wires are which from the motor ie hook blue to blue n red to red and then put onto each 30 terminal on each relay . there is a diagram of this in your install manual . also if you dont hook up the rs then you are gonna need to hook up the heavy pink wire of the relay pack so that the alarm sees ignition that will prevent a headach later.