Print Page | Close Window |
remote start on a 2002 saturn vuePrinted From: the12volt.comForum Name: Car Security and Convenience Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc. URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=41180 Printed Date: May 02, 2025 at 2:05 AM Topic: remote start on a 2002 saturn vue Posted By: SEXIFIED Subject: remote start on a 2002 saturn vue Date Posted: October 18, 2004 at 8:30 PM anyone have the wiring information for the saturn vue?
is it anything like the sedans with the disarm wire under the rear seats? i want to do locks and the usual remote start intergration. thanks in advance Replies: Posted By: Teken Date Posted: October 18, 2004 at 8:41 PM 12volts orange + ignition harness Starter yellow + ignition harness Second Starter N/A Ignition pink + ignition harness Second Ignition N/A Third Ignition N/A Accessory orange + ignition harness Second Accessory brown + ignition harness Keysense lt. green - ignition harness Notes: The lt. green key sense wire at the steering column must see a ground during remote start to keep the SERVICE light from coming on. This wire is also found in pin A11, gray 24 pin plug at BCM. Power Lock RED / black + pin A8, gray 16 pin plug at BCM Notes: The BCM (Body Control Module) is in the center of the dash behind the pocket. Power Unlock ORANGE / black + pin A7, gray 16 pin plug at BCM Notes: The BCM (Body Control Module) is in the center of the dash behind the pocket. To unlock just the driver door use a lt. green (+) wire in pin A2, gray 16 pin plug at BCM. Lock Motor gray 5wi driver kick, door harness Unlock Motor tan 5wi driver kick, door harness Parking Lights+ brown + pin B10, gray 24 pin plug at BCM Notes: The BCM (Body Control Module) is in the center of the dash behind the pocket. Parking Lights- N/A Hazards same as turn signal wires Turn Signal(L) lt. blue + steering column Turn Signal(R) dk. blue + steering column Reverse Light lt. green + kick panel, harness to rear Door Trigger gray/black (D), BLACK/ white(P) - gray 24 pin plug at BCM Notes: The driver door trigger is gray/black in pin B2. The passenger door trigger is BLACK/ white in pin A12. Use both wires and diode isolate each. The BCM (Body Control Module) is in the center of the dash behind the pocket. Dome Supervision use door trigger wire Trunk/Hatch Pin RED / black - pin B4, gray 24 pin plug at BCM Notes: The BCM (Body Control Module) is in the center of the dash behind the pocket. Hood Pin N/A Trunk/Hatch Release N/A Power Sliding Door N/A Factory Alarm Arm factory remote or passive Notes: The factory alarm is programmable for Active, Passive (5 minute delay), or Disabled. Turn ignition on, press PANIC button 8 to 10 times in 5 seconds. Within 3 seconds press UNLOCK button for Disabled, LOCK button for Active, or LOCK button twice for Passive. Factory Alarm Disarm factory remote only Notes: The factory alarm is programmable for Active, Passive (5 minute delay), or Disabled. Turn ignition on, press PANIC button 8 to 10 times in 5 seconds. Within 3 seconds press UNLOCK button for Disabled, LOCK button for Active, or LOCK button twice for Passive. Disarm No Unlock disarms with remote start Tachometer NOT pink or BLACK/ white ac ignition coil pack Wait to start N/A Brake Wire lt. blue + brake pedal switch Parking Brake lt. blue - pin A2, gray 24 pin plug at BCM Notes: The BCM (Body Control Module) is in the center of the dash behind the pocket. Horn Trigger black - pin B2, pink 24 pin plug at BCM Notes: The BCM (Body Control Module) is in the center of the dash behind the pocket. Memory Seat 1 N/A Memory Seat 2 N/A Memory Seat 3 N/A Immobilizer Bypass Module: Required: Yes Type: Passlock 2 Part #: 555L or 555T Notes: N/A This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Posted By: Teken Date Posted: October 18, 2004 at 8:49 PM Saturn Vue 2002-2004 Remote Starter Wiring Colors and Notes Function Vehicle Color Location Start: Yellow Ignition Switch Harness Ignition #1: Pink Ignition Switch Harness* Ignition #2: N/A Ignition #3: N/A *** Accessory: Brown & Orange Ignition Switch Harness**special note Brake Light: Blue or White At Brake Switch Tach Signal: White or Purple At Coil Pack Parking Lights: Brown (+) At Headlight Switch Headlights: No Color Available Please call with information OEM Alarm Disarm: No Color Available Please call with information OEM Alarm Arm: No Color Available Please call with information Diesel Glow Plug: N/A Clutch Bypass Wire: No Color Available Please call with information Notes: *May be equipped with Passlock II or PassKey III transponder anti-theft system - Use Universal Alarm Bypass Module part # 2x402 where X can be any number. **The ACC wire from the module must drive two external relays to power up the Brown & Orange wire from the vehicle. The Brown & Orange wire MUST turn ON and OFF at the exact same time or this will cause a Check Engine Light.*** Connect this wire to a lt.green(-) keysense wire to prevent CEL light to come ON, All DesignTech remote starters except the 2xx22 have an ignition 3 output - it is the WHITE/ black in the 'control harness.' This wire will be used to control the bypass module, if needed. -------------------------------------------------------------------------------- Saturn Vue 2002-2004 Alarm and Keyless Entry Wiring Colors and Notes Function Vehicle Color Location Constant +12 Volts: Orange (+) Ignition Switch Harness Starter Kill: Yellow Ignition Switch Harness Ignition +12 Volts: Pink Ignition Switch Harness* Dome Lights/Superv: Gry/Blk and Blk/white At Door Pins**** OEM Horn: Black (-) In steering Column Harness***** Power Lock: RED / Black (+) Driver Kick Panel****** Power Unlock: ORANGE / Black (+) Drivers Kick Panel****** Trunk Release: No Color Available Please call with information Alarm Input Wire: Gry/Blk and Blk/white At Door Pins**** Notes: ****Individual door circuits - Must diode isolate door pins or go directly to dome light. The color at the dome light may vary. *****CAUTION - HARNESS MAY CONTAIN AIR-BAG WIRES. TO PREVENT INJURY OR VEHICLE DAMAGE, TEST ONLY WITH A DIGITAL MULT-METER SET FOR DC VOLTS! The correct horn wire will measure 12 volts when you are not pressing the horn, zero volts with the horn sounding. ******In drivers kick panel where the rubber boot comes from the door into the body of the vehicle. See Note #202 Positive Trigger Door Locks Posted By: Teken Date Posted: October 18, 2004 at 8:50 PM WIRE COLORS LOCATION 12 VOLTS CONSTANT ORANGE IGNITION SWITCH HARNESS IGNITION 1 PINK IGNITION SWITCH HARNESS ACCESSORY /HEATER BLOWER ORANGE IGNITION SWITCH HARNESS STARTER YELLOW IGNITION SWITCH HARNESS PARKING LIGHTS ( + ) BROWN GRAY 24 PIN PLUG @ BCM PIN B10 *SEE NOTES BELOW* 1 DOMELIGHT GRAY/BLACK (L) AND BLACK/ WHITE (R) GRAY 24 PIN PLUG @ BCM *SEE NOTES BELOW* 2 POWER DOOR LOCK RED / BLACK ( + ) GRAY 16 PIN PLUG @ BCM PIN A8 *SEE NOTES BELOW* 1 POWER DOOR UNLOCK ORANGE / BLACK ( + ) GRAY 16 PIN PLUG @ BCM PIN A7 *SEE NOTES BELOW* 3 (TYPE A) TRUNK RELEASE N/A TACH SENSOR NOT PINK OR BLACK/ WHITE (AC) AT IGNITION COIL PACK BRAKE LT. BLUE ( + ) SWITCH ABOVE BRAKE PEDAL HORN BLACK ( - ) PINK 24 PIN PLUG @ BCM FACTORY DISARM DISARMS WITH REMOTE ONLY *SEE NOTES BELOW* 4 FACTORY ANTI-THEFT PASSLOCK 2 791 REQUIRED NOTES: *1 - The BCM (Body Control Module) is in the center of the dash behind the pocket. *2 - The driver door trigger is gray/black in pin B2. The passenger door trigger is BLACK/ white in pin A12. Use both wires and diode isolate each. *3 - To unlock just the driver door use a lt. green (+) wire in pin A2, gray 16 pin plug @ BCM. *4 - The factory alarm is programmable for Active, Passive (5 minute delay), or Disabled. Turn ignition on, press PANIC button 8 to 10 times in 5 seconds. Within 3 seconds press UNLOCK button for Disabled, LOCK button for Active, or LOCK button twice for Passive. |
Print Page | Close Window |