791xv Starter/antigrind
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=41200
Printed Date: May 16, 2024 at 12:49 PM
Topic: 791xv Starter/antigrind
Posted By: davidosand
Subject: 791xv Starter/antigrind
Date Posted: October 19, 2004 at 6:19 AM
I already have several spare relays mounted in a neat little box and do not want to use the relay Satelite. So, if I cut the 7-wire ribbon cable and use purple wire for my new starter relay and the ORANGE / black for a relay to interrupt the starter circuit, will that work?
Replies:
Posted By: raydawg357
Date Posted: October 19, 2004 at 9:40 AM
Personnally, I would use the set up that came with the alarm, but if you have the time to troubleshoot potential problems, go for it.
-------------
Do it right the first time
Posted By: Ravendarat
Date Posted: October 19, 2004 at 10:15 AM
791 has built in starter kill/ antigrind on it, You just cut the starter wire and hook up the heavy gauge satalie relay pack to the starter side and the heavy gauge green wire to the key side of the starter wire. All done
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Posted By: davidosand
Date Posted: October 19, 2004 at 6:53 PM
If this will work, what is the h1/1 orange wire for.
Posted By: Mark Mizenko
Date Posted: October 19, 2004 at 7:10 PM
The Org on the primary harness is also a gnd when armed lead. You could use either. And yes you could use the purp to the relay pack to trigger a starter relay.
Posted By: davidosand
Date Posted: October 20, 2004 at 6:58 PM
Thanks for the info. I have limited space in this little control box so the bulky relay satelite and wiring harness is just too much. Thanks again.
|