2002 Corolla Remote starter

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=41403
Printed Date: June 11, 2024 at 5:28 AM

Topic: 2002 Corolla Remote starter

Posted By: riypatel
Subject: 2002 Corolla Remote starter
Date Posted: October 22, 2004 at 7:19 AM

Hi,

I recently purchased ProStart Remote starter CT-3100. Was able to do most of the installation successfully in my 2002 Corolla. The door lock/ unlock just fine. But when I press the second button to start the car, it cranks the starter but the engine does not start. Any clue what could have gone wrong? I have tried reseting to factory default, tried Auto Tach programming.

Thanks in advance for your efforts.

Riyaz

Replies:

Posted By: Velocity Motors
Date Posted: October 22, 2004 at 10:09 AM

When you went to program the tach, did you get a confirmation that it was programmed proplery ? Also, what does it do when it attempts to start ? Does is crank and then die or does it run for a bit then die ?

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: riypatel
Date Posted: October 22, 2004 at 4:20 PM

Yes I did get confirmation like the manual mentioned. The parking light went off once and came back on. I went ahead to save the settings. I then tried the remote start. It cranks for over a minute but the engine does not fire.

Posted By: SEXIFIED
Date Posted: October 23, 2004 at 8:43 PM

go to the underhood and make sure that you went to the #1 injector it's the odd colour (yellow) and solder to that wire then try to re=learn, let me know.

Posted By: riypatel
Date Posted: October 25, 2004 at 10:52 AM

I was able to download wiring connection for corolla 2002 from Prostart(www.AutoStart.ca/Prostart)

here is the link:

https://206.47.191.115/pageweb.nsf/C211375925D8B09985256C2100588022/C4E2FD1B48BD7F4585256F3800559354?opendocument

here it indicates that the Tach wire can be connected to Black wire in diagnostic connector

Tachometer

Black

in diagnostic connector

I have tried that with no luck.

I will try connecting to injector #1 wire as you mentioned.

Thanks

Posted By: riypatel
Date Posted: October 31, 2004 at 12:33 PM

Hi,

I tried connecting to the yellow wire on injector #1 and re-learn tach. The programming completed successfully. However, I am still facing the same problem. Engine cranks for about a minute and does not fire.

What else could be the cause?

Thanks

Posted By: audiopro111
Date Posted: November 01, 2004 at 9:34 AM

make sure both ignitions are power up and if you installed a hood pin make sure it's not grounding out during crank to test this wire if u connected it disconnect it for a minute make sure the wire u disconnect doesn't touch ground a try to start it then.see what happens..

-------------
AudioPro111