pkm1 miata bypass module not working?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=41492
Printed Date: May 04, 2025 at 2:57 AM

Topic: pkm1 miata bypass module not working?

Posted By: sikassscivic
Subject: pkm1 miata bypass module not working?
Date Posted: October 23, 2004 at 2:20 PM

i hooked it ,only difference is the ground,so i grounded it to the chasis.it says that with the jumper on the lower pins,the LED should be on,but its not,it dosnt come on till i turn the key.after turning the key,it goes through learning fine,but after trying to start,it wont.almost like its not holding it memory,like it needs constant power and not getting it.

Replies:

Posted By: sikassscivic
Date Posted: October 26, 2004 at 12:55 PM

anyone have experiance with this?

Posted By: audiopro111
Date Posted: October 28, 2004 at 10:56 PM

not too familiar with that paticular model but usually power wire goes to constant and negative goes to negative output from remote start while remote starting usually on most manauls it goes to wire that says for example -300ma output......

-------------
AudioPro111

Posted By: auex
Date Posted: October 29, 2004 at 1:36 AM

It looks like it is supposed to have constant, the purple and purple white.

Here is the manual I found, here

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Print Page | Close Window