Print Page | Close Window

rattler 369d install in 96 blazer

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=41519
Printed Date: May 06, 2025 at 1:42 AM


Topic: rattler 369d install in 96 blazer

Posted By: brohr01
Subject: rattler 369d install in 96 blazer
Date Posted: October 23, 2004 at 8:43 PM

im in the process of installing a rattler 369d in a 96 chevy blazer without a factory alarm of any kind.

the first issue is with the parking light circuit. in the manual it says to find the wire that is 0v with the switch in the off position and 12v when switch is on. in the blazer the switch is on the ground side and has 12v in off position and 0v when the lights are on. this is on the brown wire at the parking light switch. according to the vehicle wiring guide this is the correct wire. do i just tap into that wire or do i need a diode/relay/resistor to make it work properly?

next, i am stumped as to what kind of door lock/unlock circuit i have. and if i need to use a relay/resistors/diodes to get this 369D working.

any input is great.

thanks,
bryan




Replies:

Posted By: mo12v
Date Posted: October 23, 2004 at 8:52 PM

The Parking Light wire is there....It is Brown.  Make sure U R at the Light Switch
Door locks R 12 volt + (positive) Pulse
If the outputs from your Rattler is - ( negative ) Pulse, U WILL need Relays

Parking LampBROWN (+)AT HEADLIGHT SWITCH
Power LockL BLUEDRIVER KICK
Power UnlockWHITEPANEL
Positive Pulse Door Lock



-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.


Print Page | Close Window