791xv Help
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=42211
Printed Date: May 14, 2024 at 9:48 PM
Topic: 791xv Help
Posted By: davidosand
Subject: 791xv Help
Date Posted: November 03, 2004 at 7:54 PM
I'm using the H1/1 orange wire to activate a relay that needs to stay de-energized when it is disarmed and in remote start mode. Currently the orange wire gives an output when I go to remote start, but the remote continues to display "Disarmed" Can this be changed? I have a Bitwriter. Or, is there another output that comes on "ONLY" in the "armed" state and off at other times?? Thanks, David
Replies:
Posted By: davidosand
Date Posted: November 03, 2004 at 10:34 PM
For no apparent reason the blue LED was on constantly. I couldn't seem to get any response, so with the Bitwriter I did the ZAP thing. The LED went out but I'm not sure how to re-Learn the transmitter. According to the manual, the valet button should be used. But I'm not sure I'm doing it right. I sure could use any suggestions you guys could give me. Thanks: David
Posted By: gus1
Date Posted: November 03, 2004 at 10:39 PM
Door open, ignition to "on", pres valet once, then hold. Press "lock"
Gus
-------------
Wherever I go, that is where I end up......
Posted By: davidosand
Date Posted: November 03, 2004 at 11:37 PM
I have some of the buttons working now, but the LED stays on. What;s up with that? Thanks, David
Posted By: extreme1
Date Posted: November 03, 2004 at 11:46 PM
you keep putting it into valet mode.
stop going ape on the buttons.
open door, lock-unlock-lock
-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
Posted By: sroth140
Date Posted: November 04, 2004 at 12:32 AM
open the door, turn the ignition on then off and press the valet button ONCE and you will be out of valet mode. repeat the steps to go back into valet mode.
-------------
MECP certified installer
Posted By: JWorm
Date Posted: November 04, 2004 at 12:35 AM
Turn "anti-grind" off in programming and the orange wire will function as you want it.
You realize you don't want to energize a relay the whole time the alarm is armed. It will kill your battery. What is its function? and how are you intending to wire it?
|