Print Page | Close Window

Making new light flash

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=42239
Printed Date: September 10, 2025 at 5:46 PM


Topic: Making new light flash

Posted By: Jaice
Subject: Making new light flash
Date Posted: November 04, 2004 at 1:30 PM

My alarm has an light flash output with an onboard relay, but it doesn't seem to work anymore, I've checked all the connections and everythings connected so the brain must not be sending a signal.
 
I want to make a new light flash connection, I've looked at the ones on the relay page, and was wondering if it would be possible to just run the positive siren wire to the park lights positive wire so when the alarm chirps, the lights will flash twice, and when the alarm is set off, the lights will stay on until the alarm is disarmed. But with this make the siren go off when I turn the park lights on?
 
If I use the  "Adding Light Flash with Siren Output" in the relay's page, what exactally is the circle with the X and L ?
 
 
 



Replies:

Posted By: audiopro111
Date Posted: November 04, 2004 at 6:03 PM
its a flasher

-------------
AudioPro111



Posted By: Jaice
Date Posted: November 05, 2004 at 12:36 AM
Ok, so 30 on the relay should go to the positive parklight wire?


Print Page | Close Window