2001 Tahoe and Intellistart 4

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=42549
Printed Date: May 06, 2025 at 1:36 AM

Topic: 2001 Tahoe and Intellistart 4

Posted By: mgj79
Subject: 2001 Tahoe and Intellistart 4
Date Posted: November 08, 2004 at 8:08 PM

Hey guys, I have two problems. I have installed a clifford intelliguard 8000 and a Intellistart 4 Remote Start. When I arm the car with the clifford remote, the alarm works fine. But, when I disarm the alarm, the original factory car alarm starts to honk the horn, as if someone opened one of the car doors with the factory alarm armed. How is the factory alarm being armed, and how do I disable it completey.

2nd, the intellistart is supposed to power my radio and accessories for up to 10 minutes, or until a door is opened. The RS continues to power my radio even after I open the door. It will not time out. The only way I can get it to turn off is to arm my alarm and then disarm it. Any help would be appreciated.

Replies:

Posted By: daniel2002p
Date Posted: November 08, 2004 at 9:34 PM

FACTORY DISARM

LIGHT GREEN (-)

at the PURPLE Plug, BCM, Pin B3 See NOTE *

diode isolate you unlock and this wire from the alarm, and it should solve the problem.

-------------
2005 Toyota Corolla S
1.8L VVT-i I-4
Always double check your wires with a DMM!!!
Do Not Use A Test Light!!!
MECP Certified Installer!
Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!

Posted By: mgj79
Date Posted: November 09, 2004 at 8:01 PM

Thanks for the info. After doing what you said, this only works half the time.

Posted By: mgj79
Date Posted: November 09, 2004 at 8:04 PM

How do I totally take the factory alarm out of service?