2004 chevy siverado diesel alarm/remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=43411
Printed Date: May 15, 2024 at 1:36 AM
Topic: 2004 chevy siverado diesel alarm/remote start
Posted By: derrick600
Subject: 2004 chevy siverado diesel alarm/remote start
Date Posted: November 20, 2004 at 4:39 PM
I'm installing a mannix alarm and starter in a 2004 siverado diesel crew cab and I got a wiring diagram from another site but when I try to engage the starter it doesn't work. I even tried hot wiring it over just to see but that didn't seem to work either.
And bear in mind that through all of this the key always works to start the truck.
I have both the passlock II hooked up and the multi locking thing in too. I'm thinking there is some sort of relay that the key is engaging that is not listed in my wiring diagram.
A little help hear would be great...
Replies:
Posted By: daniel2002p
Date Posted: November 20, 2004 at 5:34 PM
if you are using a starter kill, make sure that the starter wire is conncted to the correct side of it.
-------------
2005 Toyota Corolla S
1.8L VVT-i I-4
Always double check your wires with a DMM!!!
Do Not Use A Test Light!!!
MECP Certified Installer!
Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!
Posted By: forbidden
Date Posted: November 20, 2004 at 6:27 PM
Also make sure that BOTH ignition lines are hooked up. Put the key into the ignition cylinder and leave it in the off position, does the vehicle start now? If it does then you have an issue with the Passlock interface.
-------------
Top Secret, I can tell you but then my wife will kill me.
Posted By: derrick600
Date Posted: November 21, 2004 at 3:05 PM
Do I need any other bypass modules other than the passlock 2? Where I'm having problems is even when I add direct power to the starter wire it doesn't turn the starter over.
Posted By: BNLUIS
Date Posted: November 21, 2004 at 3:26 PM
make sure the accessory wires are being power as such, if power as ignition some Gm cars won't crank.
-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.
Posted By: derrick600
Date Posted: November 21, 2004 at 7:31 PM
Thanks guys, I got it going. This site has everything and thanks to everyone who replied so fast.
|