99 Durango/Clifford 3.5 ?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=43500
Printed Date: July 17, 2025 at 10:26 PM
Topic: 99 Durango/Clifford 3.5 ?
Posted By: SeanCMalloy
Subject: 99 Durango/Clifford 3.5 ?
Date Posted: November 21, 2004 at 6:44 PM
I recently installed a Clifford 3.5 alarm/rs into a 99 Durango (w/ only keyless entry). So far everyting works BUT the rs. I when I press the (*) twice to activate remote start, the remote indicates that only the first signal is received; the second is only tranmitted, and nothing happens. Does anyone know why this is? I think I hooked up (and tested) all required wires, and the remote is still at default. Any help is appreciated.
Sean
Replies:
Posted By: daniel2002p
Date Posted: November 21, 2004 at 8:20 PM
try pressing the lock and unlcok buttons tgether and see what happens.
-------------
2005 Toyota Corolla S
1.8L VVT-i I-4
Always double check your wires with a DMM!!!
Do Not Use A Test Light!!!
MECP Certified Installer!
Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!
Posted By: Teamrf
Date Posted: November 22, 2004 at 2:56 AM
Check your wires...the alarm is not engaging the starter sounds like. Make sure the green side is going to key, and the other is going to starter. Also test all of your ignitions wires... The lock and unlock buttons will throw it in program mode.
-------------
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.
Posted By: kgerry
Date Posted: November 22, 2004 at 1:43 PM
i have found with these units you have to give it a definite pulse- pause-pulse... if you hit the * button twice fast it doesnt work often
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: SeanCMalloy
Date Posted: November 22, 2004 at 7:57 PM
thanks for the responses. i have tired everyting with the remote. it stills only shows one signal being received. is there a way to reset it? i will retest the wires soon. is it possible to to fry the rs and not the alarm on the brain?
Sean
Posted By: SeanCMalloy
Date Posted: November 29, 2004 at 12:38 PM
OK, I retested the wires to find that I did not have a good connection between the neutral/safety switch and the neutral/safety wire (yellow, pin 3, 16 pin con.). Does anyone know the location of the neutral/safety wire on a 99 durango from experience, that can explain in detail where it is? What is the easiest way to get to it; can it be found anywhere else besides under the dash, maybe pcm?
Posted By: kgerry
Date Posted: November 29, 2004 at 1:43 PM
the neutral safety wire ( BLACK/ white) should connect to the supplied toggle switch and then to ground
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
|