791xv starter signal
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=43525
Printed Date: May 16, 2024 at 12:39 PM
Topic: 791xv starter signal
Posted By: davidosand
Subject: 791xv starter signal
Date Posted: November 21, 2004 at 10:37 PM
If I set the starter signal for 4 seconds but the engine actually cranks in 1 second, will the sytem stop the starter signal at that point, or will the starter continue energized for another 3seconds?
Replies:
Posted By: gcorrea
Date Posted: November 21, 2004 at 10:54 PM
it should stop, thats why it has the tach wire hooked up to it to let it know its running.
-------------
gcorrea
Posted By: davidosand
Date Posted: November 23, 2004 at 10:45 PM
But what if I use voltage sensing instead of tach sensing? Will it work the same way?
Posted By: Ravendarat
Date Posted: November 23, 2004 at 10:47 PM
I have a dumb question, why not just use tach sensing. I have never tried it the way you are suggesting because it seems completly unnessasary to me.
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Posted By: BNLUIS
Date Posted: November 23, 2004 at 10:50 PM
if you use Voltage sense it will crank for the set amount of time. if use tach it will crank until car starts. doen't matter hig long is set for. Word of advice go tach, trust me on this one.
-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.
|