Help!! Can I use the wiring diagram to hook up a remote starter, from the alarm wiring diagram? If not, does anyone have the wiring diagram for a 1989 Toyota Pickup 4x4 to hook up a remote starter.
-------------
Darrell George
Make: Toyota
Model: Pickup
Year: 1989-93
This Database Was Last Updated On: 9/16/2004
Index #: 6073
Alarm
Constant 12 volts WHITE AND WHITE/ RED IGNITION SWITCH HARNESS
Ignition 12 volts BLACK/ RED IGNITION SWITCH HARNESS
Starter BLACK IGNITION SWITCH HARNESS
Dome Light BLACK (-) 2 PIN PLUG AT FUSE BOX
Trunk Pin Switch N/A
Parking Lamp GREEN (+) AT FUSE BOX
Power Lock BLUE/WHITE DRIVER KICK PANEL OR AT CONTROL #201
Power Unlock BLUE / YELLOW UNIT BEHIND DRIVER DASH SPEAKER
#201- See Negative Pulse Door Lock Diagram.
Remote Start
Tach Signal BLACK AT IGNITER OR DIAGNOSTIC PLUG *
Ignition #2 BLACK / YELLOW IGNITION SWITCH HARNESS
Ignition #3 N/A
Accessory BLUE/RED IGNITION SWITCH HARNESS
Neutral Safety NOT GROUNDING TYPE - OEM SWITCH OPENS STARTER CIRCUIT
Brake Light GREEN / WHITE (+) SWITCH ON BRACKET ABOVE BRAKE PEDAL
Reverse Light RED / BLACK (+) AT SWITCH
Rear Window Defrost
* Diagnostic Plug Located On Side Of Fuse/Relay Box In Passenger Front Corner Of Engine Compartment, Behind Battery. BLACK Wire Marked IG-.
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Thanks, draasch this will help!!!!!!!
-------------
Darrell George
your reference to neutral switch is for automatic transmission correct? I have a 92 Toyota pickup 4x4 with manual transmission. I don't beleive there is a neutral switch from factory. Is this an option?
Thanks
You cannot use "george1" as your ID, because I am the number "one" George in all the land.
Just playing with you. Have a nice day.
Your buddy George
-------------
Cool
rider