2002 mitsubishi galant alarm/remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=43722
Printed Date: May 16, 2025 at 5:18 AM
Topic: 2002 mitsubishi galant alarm/remote start
Posted By: srusin1
Subject: 2002 mitsubishi galant alarm/remote start
Date Posted: November 24, 2004 at 5:22 PM
I am going to install a Crimestopper RS/alarm into a Galant with keyless entry. I am not sure if it has a factory security system. My question is how do i incorporate the keyless entry from the alarm. Do i just hook up the lock/unlock wires. Are there any disarm wires and how do i hook them up?Also i purchased the pku-MIT bypass, any advice on installing it?
Replies:
Posted By: daniel2002p
Date Posted: November 24, 2004 at 6:05 PM
if you vehicle has a grey igition key, then it has a factory alarm, and you will need to diode isolate the lock and unlock wires and hook them up to the arm/disarm wires as well.
-------------
2005 Toyota Corolla S
1.8L VVT-i I-4
Always double check your wires with a DMM!!!
Do Not Use A Test Light!!!
MECP Certified Installer!
Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!
Posted By: srusin1
Date Posted: November 24, 2004 at 6:13 PM
would i just run another wire from the unlock output from alarm to the disarm wire in car, and the same for arm.Is there a way to bypass the factory alarm alltogether, or do you have to arm and disarm every time enter/exit the vehicle? would there be anything else needed to make the remote start work, since it starts even when the car is armed.
|