I'm getting reday to install and ungo ms200in my 94 probe gt and was wondering if anyone knew whether the parking lights polarity must be set to pos or neg. and also the brown wire supplied for the starter defeat is continuous as it goes from the connector on the brain and back to another conector on the brain, how is it hooked up? Also the door locks will lock with +12v and unlock w/ +12v through a 4.7k ohms resistor correct?
Bryon
Here is a diagram for the car. The parking lights can be either , depending on which wire you use for the parking light circuit.:
| 12V|BLACK/ blue(or black)|+ |ignition harness |
| STARTER|BLACK / YELLOW |+ |ignition harness |
| IGNITION|BLACK/ pink |+ |ignition harness |
| ACCESSORY|blue / YELLOW |+ |ignition harness |
| POWER LOCK|GREEN/ black |*1 |driver kick panel |
| POWER UNLOCK|same wire | | |
| PARKING LIGHTS +|orange | |orn plug top of fuse box |
| PARKING LIGHTS -|green | |headlight switch |
| HEADLIGHTS|WHITE/ red |- |headlight switch |
| DOOR TRIGGER|RED / white |- |lower drivers kick |
| DOME SUPERVISION|use door trigger | | |
| TRUNK/HATCH PIN|lt. blue |- |top of fuse box *2 |
| HOOD PIN| | | |
|TRNK/HTCH RELEASE| | | |
| FCTRY ALARM ARM| | | |
|FCTRY ALRM DISARM|yellow/red |- |gray plug behind f-box |
| TACHOMETER|yellow/blue | |coil or diagn. plug |
| BRAKE WIRE| | | |
| HORN TRIGGER|GREEN/ orange |- |steering column *3 |
| WIPERS| | | |
| LF WINDOW UP/DN|grn/blu - RED / blu |A |in drivers door |
| RF WINDOW UP/DN|grn/wht - RED / wht |A |in drivers door or dkp |
Notes:
*1 Lock requires a positive trigger. Unlock requires a positive trigger through a 4,700 ohm resistor. Must use relays for both lock and unlock. *2 In a blue 22-pin plug. *3 In orange plug with air bag wires.
Starter disable diagram: https://www.the12volt.com/relays/page2.asp#sk1
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA