pku-mit programming

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=43906
Printed Date: February 21, 2026 at 3:23 PM

Topic: pku-mit programming

Posted By: srusin1
Subject: pku-mit programming
Date Posted: November 27, 2004 at 2:23 PM

when programming the bypass does the ground when starting wire have to be grounded. also is it ok for the power to be disconnected after programming,without doing the programming again?

Replies:

Posted By: srusin1
Date Posted: November 27, 2004 at 5:32 PM

Any one have some advice because i cant get this bypass to work? What security light is supposed to go on after the pku-mit programming?

Posted By: snguyen
Date Posted: November 27, 2004 at 5:36 PM

No, all you need to have is the 12 volts going to it. Once you have it programmed, you can disconnect the power and not need to reprogram it.

Print Page | Close Window