Valet 554r Question

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=43961
Printed Date: July 07, 2025 at 10:18 PM

Topic: Valet 554r Question

Posted By: gatf4
Subject: Valet 554r Question
Date Posted: November 28, 2004 at 12:55 PM

05 Chevy Equinox with passlock II bypass module.

Everything works perfect except the vehicle won't remote start unless I disarm the system first.

I have the blue wire on the Bypass module and the keysense wire on the BCM both hooked up to the Blue -200 amp output factory disarm wire on the valet system. I thought that might be the wrong wire or I have to change a setting somehow using the bitwriter. Thanks in advance.

Replies:

Posted By: Scott35
Date Posted: November 28, 2004 at 2:45 PM

I believe if you have the 2 wires hooked to the one you need to diode isolate them. To keep one from backfeeding on the other.

-------------
Tacomacrew

Print Page | Close Window