Disable Factory Keyless Entry

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=44306
Printed Date: May 04, 2024 at 12:37 AM

Topic: Disable Factory Keyless Entry

Posted By: jcjc2u
Subject: Disable Factory Keyless Entry
Date Posted: December 02, 2004 at 4:54 PM

I just bought a 01 Ford Harley Davidson Supercrew. It didnt have the keyless remote with it. (im assuming it had one before.... the lights flash when I lock the doors manually and close the doors)

Anyways Im in the process of adding an alarm. I hooked up the alarm I just havent tied into the door locks yet. But If its possible I would like to disable the factory stuff while hooking my alarm up?

Can I do it? Im hoping there is just a unit I can disconnect the power to or something.

Replies:

Posted By: 91cpe
Date Posted: December 02, 2004 at 10:21 PM

Look on the inside firewall on the drivers side and see if the keyless entry module is there. I just unplugged both connectors and everything seems ok.

Posted By: TJ92Civic
Date Posted: December 02, 2004 at 10:30 PM

why disable the factory stuff? Just wire the aftermarket in to control the factory alarm...

Posted By: 91cpe
Date Posted: December 02, 2004 at 11:54 PM

Thats another option, then you won't need to wire for the domelight or doorlocks. You could just let the factory unit control those.

Does your truck actually have a factory alarm or is it just keyless entry? I just disconnected the keyless entry because I didn't like the domelight to stay on till I put the truck in drive. I much prefer the ignition controlled light of the alarm.

Posted By: jcjc2u
Date Posted: December 03, 2004 at 6:20 AM

Thats just it. Im not sure what the vehicle has. I cant arm the thing without the remote. Well unless I get on the arm wire but Im just wanting to hook up my alarm.

Will the module have some type of Identification on it?

And where can I get the manual for a Carbine 5600?

Print Page | Close Window