factory alarm disarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=44385
Printed Date: May 12, 2025 at 4:58 PM
Topic: factory alarm disarm
Posted By: wblakes
Subject: factory alarm disarm
Date Posted: December 03, 2004 at 7:50 PM
for cars that uses the keysense wire to disarm the factory alarm, do i use the status output wire or do i use the disarm wire to pulse it?
Replies:
Posted By: gfella2000
Date Posted: December 07, 2004 at 6:19 PM
Use the disarm wire to pulse it. if the alarm you are using does not have a disarm wire just use the unlock wire of the alarm and diode isolate
-------------
GFELLA 20000000000
Posted By: JWorm
Date Posted: December 07, 2004 at 8:23 PM
I assume your probably talking about Toyota's. You need to use the status out. Disarm won't work.
Posted By: dantemc
Date Posted: December 08, 2004 at 1:16 AM
if you are using a dei module and you are talking about disarm for remote start plus during unlock, use the GREEN/ black disarm wire. its a dedicated disarm wire and it will disarm when you remote start, or if you are unlocking the doors. if you are just doing a remote start, you can use the status, or if you are just doing an alarm, the unlock wire will work for that.
|