hi all
looking for wiring diagram for dodge ram 1500 year 2002
thanx in advance
Remote Starter Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Start: | | YELLOW | IGNITION SWITCH HARNESS |
Ignition #1: | | BLUE (16 AWG) | IGNITION SWITCH HARNESS |
Ignition #2: | | RED | IGNITION SWITCH HARNESS |
Ignition #3: | | GREEN & ORANGE (2 WIRES) | IGNITION SWITCH HARNESS |
Accessory: | | BLACK/ WHITE & BLUE (2 WIRES) | IGNITION SWITCH HARNESS |
Brake Light: | | WHITE/ TAN | AT SWITCH ABOVE BRAKE PEDAL |
Tach Signal: | | TAN/RED | AT IGNITION COIL |
Parking Lights: | | PURPLE / YELLOW | HEADLIGHT SWITCH* |
Headlights: | | PURPLE / YELLOW | HEADLIGHT SWITCH * |
Diesel Glow Plug: | | ORANGE / Black | Powertrain Control Module*** |
Clutch Bypass Wire: | | | |
Notes: | | * This Is A Single Wire System. Parking Lights Need To See A Ground (-) Through A 330 Ohm Resistor. Headlights Need To See A Ground (-) Through A 700 Ohm Resistor. ** Diesel Vehicles - ORANGE / Black Wait to Start; Tach Wire Is Gray/Black. Both Wires Are Located In A Black Connector Center Top Of Fire Wall. There Are Two Black Connectors, The Correct One Does Not Have A White Insert. *** Tach can also be located at pin 74 behind instrument cluster. |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Constant +12 Volts: | | PINK/BLACK | IGNITION SWITCH HARNESS |
OEM Alarm Disarm: | | LT. GREEN/ ORANGE ***** | HARNESS COMING IN FROM DRIVER'S DOOR |
Dome Lights/Superv: | | SEE NOTE *** | |
OEM Horn: | | BLACK/ RED (-) | STEERING COLUMN HARNESS |
Power Lock: | | WHITE/ GREEN | DRIVER'S KICK PANEL **** |
Power Unlock: | | WHITE/ GREEN | DRIVER'S KICK PANEL **** |
Trunk Release: | | N/A | |
Alarm Input Wire: | | SEE NOTE *** | |
Notes: | | *** Separate Triggers For Each Door. The Driver's Door Trigger Is Tan (-). The Left Rear Door Trigger Is Tan/Orange (-). Both Wires Can Be Found In The Driver's Kick Panel. The Passenger Front Door Trigger Is Tan/Red (-) And the Passenger Rear Door Trigger Is Tan / YELLOW (-). Both Of These Wires Can Be Found In The Passenger Kick Panel. Diode Isolate Each Wire For Alarm Trigger With The Bands Facing Away From The Alarm/Remote Start Module. Use Only One Trigger For Dome Light Supervision. **** Single Wire Door Lock System See Note #211. Lock Requires A Ground (-) Pulse Through A 867 Ohm Resistor. Unlock Requires A Ground (-) Pulse Through A 364 Ohm Resistor. Diode Isolate One Of The Wires. ***** Requires A Negative Pulse Through A 1.5 K-Ohm Resistor. |
-------------
2005 Toyota Corolla S
1.8L VVT-i I-4
Always double check your wires with a DMM!!!
Do Not Use A Test Light!!!
MECP Certified Installer!
Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!