Print Page | Close Window

Help with 2005 toyota Sequoia door wires

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=44724
Printed Date: May 07, 2025 at 9:06 PM


Topic: Help with 2005 toyota Sequoia door wires

Posted By: doityourself
Subject: Help with 2005 toyota Sequoia door wires
Date Posted: December 08, 2004 at 1:18 PM

Could someone please help me what color of wire and plug for rear  left/right door trigger wires .

I took the door trigger out and see driver rear door is BLACK/ oranger and passenser rear is BLACK/ orange ans silver dot.      I don't a wire from the driver kick panel that is black orange lead to the back.    I see 1 BLACK/ oranger and silver dot behind the kickpanel on the passenger side that lead to the back but it's not the right one.  because I tried to ohm it and it's not ohming out.

thanks for the help.  in advance..




Replies:

Posted By: mxxmikexx
Date Posted: December 08, 2004 at 11:14 PM
Door Trigger see notes   -   BECU above driver kick
Notes: The LF door is gray/red in the black plug, pin 12. The RF door is lt. GREEN/ black in the white plug, pin 22. The LR door is RED / white in the black plug, pin 7. The RR door is RED / white in the white plug, pin 8. Use all four wires and diode isolate each.




Print Page | Close Window