790xv programming
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=44825
Printed Date: May 16, 2024 at 8:23 AM
Topic: 790xv programming
Posted By: patmo
Subject: 790xv programming
Date Posted: December 09, 2004 at 5:03 PM
Hi,
I am able stop alarm with the valet switch but I am not able programming the remote control whit the valet switch.
please help!!
Replies:
Posted By: kgerry
Date Posted: December 09, 2004 at 6:45 PM
the programming mode may have been "locked" with a bitwriter by the original installer....
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: patmo
Date Posted: December 09, 2004 at 8:02 PM
But the remote control do not make any function (not arm, not disarm ect...)
Posted By: patmo
Date Posted: December 09, 2004 at 8:08 PM
patmo] wrote:
DIV style="PADDING-RIGHT: 10px; PADDING-LEFT: 10px; PADDING-BOTTOM: 10px; PADDING-TOP: 10px">But the remote control do not make any function (not arm, not disarm ect...) I don't connect the starter kill but the yellow wire on this relay is a connect on ignition or not a differance.
Posted By: Autoobsession
Date Posted: December 09, 2004 at 9:52 PM
To program the remote you must have Ignition 1 Connected to the Pink wire. Also the green or Purple wire for the door trigger must be connected. Turn the key on and then press the valet button. Press it again and hold it. The siren should chirp once. Then press the lock button on the remote and the siren will sound. The remote is then programmed to the default settings. -------------
Posted By: profuse007
Date Posted: December 09, 2004 at 10:25 PM
try this, think its for 791xv reomtoe
Programming instructions:
Turn key on, hit valet button 8 times, press a ninth time and hold. Siren chirps 8 times....hit lock on remote. Release valet button.
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: auex
Date Posted: December 09, 2004 at 10:33 PM
If the alarm is locked with the bitwriter it should beep at you when you even attempt to go into programming. If the alarm acts like it is going into programming but not completing it then your remote could be bad, the alarm could be bad, or it could be locked(but like I said it shouldn't even let you get to the point of programming).
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: patmo
Date Posted: December 10, 2004 at 7:31 AM
It,s possible unlocked whitout the bitwriter but it's a new alarm never installed in a car !!!
|