Pro Start problems in 1997 Grand am
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=44930
Printed Date: April 23, 2024 at 2:43 AM
Topic: Pro Start problems in 1997 Grand am
Posted By: Bubbabossert
Subject: Pro Start problems in 1997 Grand am
Date Posted: December 11, 2004 at 4:48 AM
Installed pro start in car bought plxr bypass module cant find bulb test wire and will not run. Problem is the theft system and cant figure out why will not run. Had wiring diagram for car, showed bulb test wire at pin F and ignition switch but no indication of any signal on that wire.(used logic probe) No power or ground on probe. Think I have keysense wire right any ideas. Should be passlock 1 because of wire colors at key thanks in advance
Replies:
Posted By: seracis
Date Posted: December 11, 2004 at 5:24 PM
the bulb test wire is found in the same plug as the red constant wires, on the back of the steering assembly, once you remove the column shroud. I think it shows ground only while starting.
Posted By: seracis
Date Posted: December 11, 2004 at 5:24 PM
the bulb test wire is found in the same plug as the red constant wires, on the back of the steering assembly, once you remove the column shroud. I think it shows ground only while starting.
|