Crimestopper remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=44963
Printed Date: June 27, 2025 at 6:16 PM

Topic: Crimestopper remote start

Posted By: JMORTON
Subject: Crimestopper remote start
Date Posted: December 11, 2004 at 4:21 PM

I recently got a used Crimestopper remote start system. I'm trying to test it before installing it and I'm not gatting any signal on the starter wire after hiting the start buttons on the remote. Should I get a constant 12v or just a burst? Am I correct in thinking I can test it this way or does everything have to be hooked up for the system to work?

Replies:

Posted By: ksutton
Date Posted: December 11, 2004 at 8:42 PM

you should get a 1-2 second 12v pulse

Posted By: lspker
Date Posted: December 11, 2004 at 9:08 PM

You may not get start signal until you program tach. Check if your getting light flashing code for no tach.

Posted By: furredoutgixxer
Date Posted: December 11, 2004 at 10:12 PM

also check and make sure the wait to start wire is taped off. (might be labeled glow plug)

Posted By: JMORTON
Date Posted: December 16, 2004 at 2:32 PM

So I should probably go ahead and install it and hope it works?

Print Page | Close Window