I am having trouble configuring a Bulldog RS82 in a Ford Escape 02. I have two major problems!
Problem One:
I have wire and programmed the RS82 unit so that I could use the factory keyless entry remote to start the car starter. Problem is, I am able to start the car using the Bulldog remote but I have not been successful with the factory keyless entry remote.
With further Diagnostic:
- When I touch the AMA wire to a ground (3 times consecutively) it will activate the starter and start the car.
- If I probe the pink /black* wire I so no voltage and when pressing the lock button I see 12 voltage positive (before the relay) though I did notice that it is a fast trigger.
(…Could it be too fast for the relay to react?)
NOTE:
* The wiring diagram states that I should be using the pink/white wire, but after a quick test I discovered that the pink/black wire is the right one because the pink/white is providing a constant 12 volts.
Problem Two:
When I start the car using the RS 82 auto starter and the bulldog remote, the Ford remote does not work but when I to turn off the car using the Bulldog remote then the Ford remote will work again.
Wire details:
From the Bulldog RS82 rev.P Ford Escape 02
(Remote starter)
2- FASD (red/black) -------------------- Dark Blue/Light Green
3- Tach (-) ---------------------------------N/ C
4- Hood Pin Input (BLACK/ Blue) ------Hood Pin
5- AMA Input (blue) --------------------RELAY (inverter) – Pink/Black
(12+ when door close button is activated)
6- Factory By pass (Ylw/Black) ------ to Bulldog 791 Bypass Unit
7- Brake Input (Blue Black) ---------- Brake Input
8 - Parking Light ( Brown) ----------- to Park light
9 – Ground (Black ---------------------- Ground
Can anyone help me here?
Let me try this again ....
I am having trouble installing a Bulldog RS82 in a Ford Escape 02. Can anyone help me?
Problem One:
I have wire and programmed the RS82 unit so that I could use the factory keyless entry remote to start the car starter. Problem is that I am able to start the car using the Bulldog remote but I have not been successful with the factory keyless entry remote.
Further Diagnostic:
- When I touch the AMA wire to a ground (3 times consecutively) it will activate the starter and start the car.
- If I probe the pink /black* wire I so no voltage and when pressing the lock button I see 12 voltage positive (before the relay) though I did notice that it is a fast trigger.
(…Could it be too fast for the relay to react?)
NOTE:
* The wiring diagram states that I should be using the pink/white wire, but after a quick test I discovered that the pink/black wire is the right one because the pink/white is providing a constant 12 volts.
Problem Two:
When I start the car using the RS 82 auto starter and the bulldog remote, the Ford remote does not work but when I to turn off the car using the Bulldog remote then the Ford remote will work again.
Can you help?
From the Bulldog RS82 rev.P Ford Escape 02
(Remote starter)
2- FASD (RED / black) -------------------- Dark Blue/Light Green
3- Tach (-) ---------------------------------N/ C
4- Hood Pin Input (BLACK/ Blue) ------Hood Pin
5- AMA Input (blue) --------------------RELAY (inverter) – Pink/Black
(12+ when door close button is activated)
6- Factory By pass (Ylw/Black) ------ to Bulldog 791 Bypass Unit
7- Brake Input (Blue Black) ---------- Brake Input
8 - Parking Light (Brown) ----------- to Park light
9 – Ground (Black ---------------------- Ground
I have solve it!