Print Page | Close Window

2001 monte carlo remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=45197
Printed Date: May 02, 2024 at 6:21 PM


Topic: 2001 monte carlo remote start

Posted By: danh0ward
Subject: 2001 monte carlo remote start
Date Posted: December 14, 2004 at 12:41 PM

I need a rs diagram for a 2001 chev monte carlo   thanks

-------------
Dan Howard



Replies:

Posted By: rudbwoy69camaro
Date Posted: December 14, 2004 at 2:23 PM
2001 Chevrolet Monte Carlo

ItemWire ColorPolarityWire Location
12Vred+ignition harness *1
STARTERyellow+ignition harness *1
IGNITIONpink+ignition harness *1
ACCESSORYorange+ignition harness *1
SECOND ACCESSORYgreen+ignition harness *1
TACHOMETERwhiteignition coil
POWER LOCKORANGE / black*2gray 24-pin plug @ BCM *3
POWER UNLOCKsame wire as lock-gray 24-pin plug @ BCM *3
PARKING LIGHTS +do NOT use
PARKING LIGHTS -white *8pink 24-pin plug @ BCM *3
DOOR TRIGGER*5-gray 16-pin plug @ BCM *3
HEADLIGHTSyellow-gray 24-pin plug @ BCM *3
WIPERS
LF WINDOW UP/DNblue - brownAdrivers window switch
RF WINDOW UP/DNlt. blu - tanAdrivers door harness
LR WINDOW UP/DNgreen - purpleAdrivers door harness
RR WINDOW UP/DNlt. grn - purpleAdrivers door harness
TRUNK/HATCH PINRED / black-gray 24-pin plug @ BCM *3
HOOD PINnone
TRUNK/HATCH RELEASEblack-release switch
FACTORY ALARM ARMnone
FACTORY ALARM DISARMlt green-gray 16-pin plug @ BCM *3
HORN TRIGGERblack *6-steering column
BRAKE WIREwhite+brake switch
LOCK MOTOR*4
UNLOCK MOTOR*4
DISARM DEFEAT*4
DISARM NO UNLOCKnone
DOME SUPERVISIONuse door trigger
SPEED SENSEgreengray 16-pin plug @ BCM *3
SUN ROOF OPEN/CLOSE
SUN ROOF LIMIT
LF SPEAKERnone
RF SPEAKERnone
LR SPEAKERnone
RR SPEAKERnone
RADIO 12Vnone
RADIO GROUNDnone
RADIO SWITCHnone
RADIO ILLUMINATEnone
POWER ANTENNAnone
 
Notes:NOTE: This vehicle has the passlock II immobilizer system that, when adding a remote start, must be interfaced with. Use DEI part 555t or 555L. *1 The ignition harness is located far right of the steering column, behind the ignition switch. *2 Lock and unlock use the same wire. Lock requires a negative trigger with a 470 ohm resistor in-line. Unlock is negative trigger. Must use relays. *3 The BCM is located above the brake pedal. It is a plastic box with three plugs that face the firewall. *4 Installation of factory keyless upgrade alarm is not recommended on this vehicle because the door lock motor wires rest at approximately 7 volts. *5 The drivers door trigger wire is blue. Blue/white will catch the passenger door. Use both wires and diode isolate each. *6 Horn can also be found at the black plug with a blue insert above the gas pedal. *7 This wire must be powered as an accessory wire. If powered as an 2nd ignition the car will not crank. *8 Must isolate this wire from the BCM when doing remote start to avoid 'service engine soon' light. See directfax document #1600 for wiring information.



-------------





Print Page | Close Window