Clifford Intelliguard 700 IQ Troubleshoot
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=45310
Printed Date: July 18, 2025 at 7:31 PM
Topic: Clifford Intelliguard 700 IQ Troubleshoot
Posted By: bigpappy
Subject: Clifford Intelliguard 700 IQ Troubleshoot
Date Posted: December 15, 2004 at 8:03 PM
My car alarm appears to have died when the battery was disconnected by a mechanic. It survived 2 disconnects in the past 3 weeks (spark plug change and new battery). This was just to install the battery shield the idiot left sitting on top the engine when they changed the battery. Alarm is non-responsive to valet switch and remote.
Alarm installer is no longer in the business and dealership couldn't locate anybody who knew this alarm. They tried calling Clifford w/o luck and from prior experience I don't expect much from clifford.
Any troubleshooting hints or places for the mechanic to contact?
Replies:
Posted By: hagmanti
Date Posted: December 16, 2004 at 11:28 AM
Disconnect the alarm-- if there are harness going into the main brain, disconnect them for several minutes (even an hour), and then reconnect them up. (Make sure you know where your valet key is-- this is likely to trip the alarm).
If that doesn't fix the problem, your brain may have finally given up the ghost, and it may be time for a brand-spanking new alarm...
Me
Posted By: auex
Date Posted: December 16, 2004 at 12:15 PM
Check the fuses for the alarm, reconnecting the battery could have potentionaly blown the fuse.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
|