programming Bulldog remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=45750
Printed Date: May 10, 2025 at 7:09 AM
Topic: programming Bulldog remote start
Posted By: foltzy
Subject: programming Bulldog remote start
Date Posted: December 22, 2004 at 8:08 AM
i need to know if anyone has any information on how to reprogram a Bulldog remote start system. its for a friend who had her battery disconnected by the garage and its hasn't worked since.
Replies:
Posted By: jaurora
Date Posted: December 22, 2004 at 10:45 AM
There is no reprograming for these remote starts. Most likely it is the remote. It may be a coincidence that this happened since the shop. I dont perfer bulldog but I have also installed them. No programing is required. It also learns tach rate automatically.
-------------
MECP certified (If it really means anything)
Jeremy
Posted By: intuitionx2
Date Posted: January 05, 2005 at 9:16 PM
I had to program mine (deluxe 500). You may have to reprogram the remote / Tach or volt check etc. They have manuals online for all current models except the 500 deluxe.
See: https://www.bulldogsecurity.com/install.htm
-------------
:)
Posted By: Falcon 1
Date Posted: January 05, 2005 at 10:30 PM
Usually all you need to do is unplug the harnesses from the main unit on the Bulldog. Then you replug them in and push any button on the remote.
-------------
Do it right the first time, only a doctor can bury his mistakes.
Posted By: dearfriend
Date Posted: January 06, 2005 at 11:34 AM
Step 1: Press and hold the breake pedal
Step 2: Turn your key in the ignition to from OFF to IGN 5 times in 4 seconds (or vice versa, sorry don't remember correctly). Lights will flash 3 times
Step 3: Try the remote - it should not work. Take out fuses from thick red wires for about 1 minute (bulldog has 2 of them). Your unit's memory should be cleared.
Step 4: Put fuses back and press button 4 (Stop - red button) on the remote control. Lights will flash 3 times. Your unit now learned the remote.
Should work from this point. Good luck!
Posted By: dearfriend
Date Posted: January 06, 2005 at 11:34 AM
Step 1: Press and hold the breake pedal
Step 2: Turn your key in the ignition to from OFF to IGN 5 times in 4 seconds (or vice versa, sorry don't remember correctly). Lights will flash 3 times
Step 3: Try the remote - it should not work. Take out fuses from thick red wires for about 1 minute (bulldog has 2 of them). Your unit's memory should be cleared.
Step 4: Put fuses back and press button 4 (Stop - red button) on the remote control. Lights will flash 3 times. Your unit now learned the remote.
Should work from this point. Good luck!
|