Print Page | Close Window

new remote start questions

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=45862
Printed Date: July 18, 2025 at 6:03 AM


Topic: new remote start questions

Posted By: My3rdBaby
Subject: new remote start questions
Date Posted: December 23, 2004 at 3:12 PM

ive searched for this and couln't find anything. ive just about got everything hooked up but i was wanting to get some solutions for...

1. My heater/air conditioner won't work (the only thing i've found on this was somebody saying to join two wires in the ignition harness???) where is the wire that i hook up to for this?
and
2. There is a wire that sends a signal to the alarm when the car starts, the instructions say a wire that has negative polarity when the car is off, and positive polarity after the car has started. what is the easy and most common place to hook up this wire?

oh and by the way, the alarm i got was one of those generics off ebay

thanks



Replies:

Posted By: misterjimbo
Date Posted: December 23, 2004 at 3:26 PM
dont join two wires together. use a relay to power up the other acc circuit. waht kind of car is it? is it an alamr and start combo or two seperate units?

-------------




Posted By: My3rdBaby
Date Posted: December 23, 2004 at 3:30 PM

it's a alarm with starter combo

'89 honda prelude thanks for the reply





Posted By: audifive
Date Posted: December 23, 2004 at 3:30 PM
what kind of car is this for?  many cars have more than one accessory wire that you must power in order to get the heater powered during a remote start.  im not sure what you mean by the second question.  what did you buy? a remote starter, or an all in 1 remote start/keyless/alarm?




Posted By: My3rdBaby
Date Posted: December 23, 2004 at 3:34 PM
*also* there is a single wire that comes out of the main alarm module, which is in the same harness as the ignition wires, that is strictly supposed to be for the a/c and heater.




Posted By: My3rdBaby
Date Posted: December 23, 2004 at 3:39 PM

posted_image 





Posted By: My3rdBaby
Date Posted: December 23, 2004 at 3:42 PM

heres the diagram

my car is a 1989 honda prelude si

the wires i'm reffering to is the GREEN wire that is with the ignition harness and the PURPLE wire in the 5 P connector, at the top of the page thanks again for your help





Posted By: misterjimbo
Date Posted: December 23, 2004 at 3:46 PM
dont have time to help now, but if it can wait till late tonight or early tom. i will post some info for you. keep checking for other replies lots of good people on this site.

-------------




Posted By: My3rdBaby
Date Posted: December 23, 2004 at 3:50 PM
thanks again




Posted By: misterjimbo
Date Posted: December 24, 2004 at 12:43 AM
the green wire should be conected to either the yellow or the white black wire at the ign harness. by the looks of the diagram it looks like both the green wire and brown wires are acc wires. i am not sure. i do not like the diagram that they give you. i am asleep as i write this so maybe i will be able to read better in the morning.

-------------




Posted By: KarTuneMan
Date Posted: December 24, 2004 at 1:17 AM

It looks to me like the blue and the green are accs. wires from the brain......Hook those to the 1st and 2nd accs. wires at your ignition harness

Yellow is accs. 1

white /black is accs. 2

The diagram is hard to read on this post



-------------




Posted By: My3rdBaby
Date Posted: December 24, 2004 at 3:55 PM
thanks ill try this and let you guys know. thanks for your help




Posted By: gcorrea
Date Posted: December 24, 2004 at 6:46 PM
not sure about the purple wire kind of hard to see the diagram, but the green wire goes to your accesory wire that power your ac or heater.

-------------
gcorrea




Posted By: My3rdBaby
Date Posted: December 27, 2004 at 12:36 PM

okay heres the updtae*

i figured it out by pooking the green wire into te back of the wire harness (trial and error) the reen wire hooks up to the blue/white wire, in the ign harness and i just hooked up the purple wire to the positiove side of my msd ignition coil. i don;t know if thats where the purple wire goes, but it's working!

thanks for all the replys!






Print Page | Close Window