BOA 265B / 2000 Grand Caravan

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=45900
Printed Date: July 05, 2025 at 7:22 PM

Topic: BOA 265B / 2000 Grand Caravan

Posted By: peridigm
Subject: BOA 265B / 2000 Grand Caravan
Date Posted: December 23, 2004 at 11:19 PM

My first question is do I have to wire the door locks for the unit to work or can I just wire the remote start? I did wire the remote start only. I am 100% confident my wiring is correct. When I perform the program sequence, the parking lights flash twice as they are supposed to. I can hear the remote start module click. When I try to start the car, the starter does not engage. I did not install the door lock harness because I don't have the resistors yet.

If I am reading the tech info correctly my van uses multiplexed locks with negative trigger. Anyone care to back me up on this?

Any help is much appreciated.

Replies:

Posted By: KarTuneMan
Date Posted: December 24, 2004 at 1:09 PM

12v pink and black

Ign. blue

2nd Ign.dk.grn. and red 18 g.

Start yellow

Accs. black orange all of these are hooked up correct?

-------------

Posted By: KarTuneMan
Date Posted: December 24, 2004 at 1:13 PM

Your description of the door locks is 100% right on the money dude

1.5k ohms to lock 250k ohms to unlock

-------------

Posted By: KarTuneMan
Date Posted: December 24, 2004 at 1:14 PM

Your description of the door locks is 100% right on the money dude

1.5k ohms to lock 250k ohms to unlock

USE

-------------

Posted By: KarTuneMan
Date Posted: December 24, 2004 at 1:14 PM

Your description of the door locks is 100% right on the money dude

1.5k ohms to lock 250k ohms to unlock

USE A

-------------

Posted By: KarTuneMan
Date Posted: December 24, 2004 at 1:15 PM

sorry bout that.... use 2 relays

-------------

Posted By: peridigm
Date Posted: December 24, 2004 at 3:25 PM

Please excuse my ignorance. Where do I get the relays? Yes, all of the ignition wires are hooked up, except for the accessory. I read in the tech data on Boa's website that the accessory wire is not used. Could that be my starting problem?

Thanks.

Posted By: peridigm
Date Posted: December 24, 2004 at 3:40 PM

I checked and the colors you referenced for the 12v and ignition wires don't match what I found in my van. I used the directed tech document for my model and everthing checks out right.

Wire running from tach to module registers correct voltage at idle and during acceleration.
Hood pin checks open when hood is closed and closed when hood is open.

I will hook up the accessory wire anyway to see if that makes a difference.

Posted By: peridigm
Date Posted: December 26, 2004 at 4:29 PM

It's working. It was a programming issue like others are having. I had to stand farther away than the 3 feet specified by the manual.