Print Page | Close Window

Help for Remote Start on 99 Ram

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46158
Printed Date: May 15, 2025 at 8:59 AM


Topic: Help for Remote Start on 99 Ram

Posted By: Ajusted
Subject: Help for Remote Start on 99 Ram
Date Posted: December 27, 2004 at 9:15 PM

Installed DEI Valet 562T in 2003Nissan Altima.  RS starts car then it immediatly dies.  It still starts and dies with key in ignition and OFF.  RS starts car with key in ignition and ON. 

I have the relay wire connected as follows:

Purple  to starter side of cut RED / Black starter wire

Green to Key side of cut RED / Black starter wire

Both Red wires connected to Green wire from ignition

Orange connected to Red wire from ingnition

Pink/White connected to WHITE/ Blue wire from ignition

Pink connected to uncut BLACK/ Red from ignition. 

8617 Relay Brown connected to BLACK / YELLOW from ignition

8617 Relay Yellow connected to Green wire from ignition (constant +12v)

8617 Relay Red connected to Green wire from ignition (constant +12v)

8617 Relay Black connected to Purple (-) 200mA Remote start Aulillory 4 pin harness

Shutdown diagnostics shows six flashes (+/-) Shutdown

The Tach has been learned and indicates a solid status light.  A dmm on the tach lead shows approx 2VAC on the tach input at RS

Please Help!!




Replies:

Posted By: mrwhitehat
Date Posted: December 27, 2004 at 9:16 PM

Car:  1999 Dodge Ram 1/2 ton Sport
Install:  Marksman 6a Remote Start / Remote keyless entry
Problem:  Remote Start not working at all.  Cannot enter programming mode.

I have verified that everything is hooded up to what it should be and tested it with a meter.  I tried adding the Ignition 2 output, but it did nothing.
I have verified that the Negative and positive safety shutdowns as well as the Neutral Safety Switch Input are working properly (with a meter).

The remote works for the unlock/lock (you can here the relays going off) and the red led flashes with the locked (armed) function.
Horn honks and lights flash appropriately with the lock and unlock, but NOTHING with the remote start!  It does nto even appear to be receiving.

Here is how we have things hooked up:
The format is as follows - Wire Color:  Off Voltage/Acc-Run Voltage/Start Voltage to Marksman Harness Wire Color/Description

Red Wire:  12/12/12 to Red Wire(2)/+12 Battery Input
Blk/White Wire:  0/12/0
Blk/Orange Wire:  0/12/0
Pink/Black:  12/12/12
Dark Blue Wire:  0/12/12 to Yellow Wire/Ignition 1 Output
Yellow:  0/~0/11 [starter] to Violet Wire/Starter output


Print Page | Close Window